HiB 49400 Руководство - Страница 3
Просмотреть онлайн или скачать pdf Руководство для Внутренняя отделка HiB 49400. HiB 49400 4 страницы. Led illuminated steam free cabinets
Печатать страницу
top front edge of the cabinet to gain access to
the internal panel(s). (Fig. E) Keep screws in a
safe place.
7. Temporarily hang the cabinet ensuring the
claws on the hangers are securely located on
the wall brackets. Using a spirit level adjust the
cabinet via the screws on the hangers. (Fig. E).
8. Mark the position of the internal fixing hole and
remove the cabinet. Using a suitable drill bit,
drill a hole and insert a wall plug as per stage 4.
9. Connect the cable at the rear of the cabinet
to the mains supply cable using a suitable
terminal block (not supplied) according to the
wiring diagram (Fig. 2) on the back page.
10. Rehang the cabinet in position, tighten the
screws on the hangers (Fig. E) and secure the
base of the cabinet with the supplied screw
and screw cap.
11. Once fully secure, close the internal panel(s)
using the screws removed at stage 6.
12. Fit shelves in desired positions using shelf
supports.
13. Re-attach the door(s), ensuring the connector(s)
are reconnected correctly. Feed excess wire(s)
back into the carcass before re-attaching the
hinges back into position.
14. If necessary, the hinges can be adjusted in
order to reposition the door(s) (Fig.F).
15. Switch the mains supply back on.
Move door(s) up/down
Move door away/towards
the cabinet
Move door(s) left/right
Door Adjustment (Fig F)
Operating Instructions
To turn illumination on or off, wave your hand
under the sensor switch located at the bottom
of the cabinet. Charger socket is suitable
for charging and powering electric razors,
trimmers and toothbrushes. Heated pad is only
on when the cabinet is illuminated.
NB. On first use of the charger socket,
inserting the shaver plug may prove to be stiff.
Reasonable force may be required to fully insert
the plug. Make sure that the cabinet is held
firmly so that it is not pushed off the wall. After a
few uses, stiffness will ease and the socket will
function as normal.
How to isolate the sensor so you can
switch ON & OFF with a mains switch.
How the cabinet is wired.
live
earth
neutral
Shaver socket/transformer
Sensor switch controller
LED driver
How to isolate the sensor.
live
earth
neutral
Shaver socket/transformer
Sensor switch controller
LED driver
Rewire the cabinet as shown in the diagram
above. HiB recommends that all electrical
bathroom products should only be fitted by a
suitably qualified, Part P registered electrician.
For further assistance on isolating the sensor
please contact us.
Tel:
020 8441 0352
Email:
hib.co.uk
3