HiB 54500 Руководство по монтажу - Страница 6

Просмотреть онлайн или скачать pdf Руководство по монтажу для Внутренняя отделка HiB 54500. HiB 54500 8 страниц.

Installation

Before installation, ensure the domestic electrical mains supply to which the

cabinet is to be connected is turned off. Before drilling, ensure that there are

no hidden cables or pipes in the wall.

It is recommended that this product is installed by two people.

1. Position the cabinet in a suitable location, according to the zonal diagram Fig.

1, ensuring that the mains supply cable is within reach of the cable connection

point of the cabinet. Carefully mark the desired position of the cabinet using a soft

pencil, ensuring it is level.

2. Remove the cabinet from the wall and using a spirit level, mark a horizontal line

below the pencil mark, taking into account the location of the mounting points,

Place brackets on the line and carefully mark the position of the holes using a soft

pencil, see Fig. 2.

3. Before drilling, ensure there are no hidden cables or pipes behind the

mounting point. Using a suitable drill bit, drill holes in the marked positions to a

suitable depth.

4. Insert wall plugs level with the surface of the wall. If fitting to a tiled surface,

wall plugs should be inserted below the tile surface to avoid cracking. NB. For

plasterboard walls, specialist fixings should be purchased from any DIY or

hardware store.

5. Fix the brackets to the wall using the screws provided.

6. Temporarily hang the cabinet on the top bracket, see Fig. 3, to mark the

position of the internal fixing hole, then remove the cabinet. Using a suitable drill

bit, drill a hole and insert a wall plug as per stage 3.

7. Connect the cable at the rear of the cabinet to the mains supply cable using a

suitable terminal block (not supplied) according to the wiring diagram on page 3.

10. Rehang the cabinet in position and secure the base of the cabinet with the

supplied screw(s) and screw cap(s).

11. Adjust the shelf supports provided by loosening the securing screw and

slide up or down to the required position inside of the cabinet. Tighten bracket

securing screw when finished. Slide the glass shelf into the brackets when

finished and secure in place by tightening the securing screws, see Fig 4.

12. Switch the mains supply back on.