HiB Parity Краткое руководство - Страница 3

Просмотреть онлайн или скачать pdf Краткое руководство для Внутренняя отделка HiB Parity. HiB Parity 4 страницы. Recessed cabinets

Replace Caps & Diffusers

Fixing into recess

(Fig E)

Recessed Installation

Before installation, ensure the construction of the partition wall is suitable to allow the cabinet to fit

tightly into the recess. The cabinet should be placed in a suitable location, (according to the zonal

diagram (Fig. 1) on the back page). Ensure that the domestic electrical mains supply is within reach of the

electrical connection point of the cabinet.

Remove caps using a suitable screw driver, then remove diffusers & light tubes. (See fig. D).

Position the cabinet in the recess, and mark the positions of the fixing holes of the cabinet using a

soft pencil. Then remove from wall.

See stage 3 of the wall hung installation process opposite.

Connect the domestic mains supply according to the wiring diagram (Fig. 2) on the back page.

Slot cabinet into recess and using a suitable screwdriver, screw cabinet onto stud wall. (See Fig. E).

Replace lighting tubes & diffusers and replace top & bottom caps with supplied square caps for

recessed mounting. (See fig. D2).

Follow stage 11 to 13 of the wall hung installation process opposite to complete installation.

Operating Instructions

To turn illumination on or off, wave hand past the sensor switch on the right side of the cabinet.

To operate charging socket, use pull cord located next to socket. Socket is suitable for recharging

toothbrushes, shavers and trimmers. NB. On first use of the charger socket, reasonable force may be required

to fully insert the plug. Hold the cabinet firmly so that it is not pushed off the wall. After a few uses, stiffness will

ease.

Lamp Replacement

Requires 2x T4 lamps, Max 22W

CAUTION: Allow at least 30 minutes after lamp failure before replacing. Ensure the domestic electrical

mains supply to which the product is connected is turned off.

1. Remove top or bottom caps using a suitable screw driver. Then remove diffusers & light tubes.

2. Place new lighting tubes, then replace diffusers and top or bottom caps.

(Fig D)

Shelf Adjustment

(Fig F)

Move door(s) up/down

Move door away/towards

the cabinet

Move door(s) left/right

Door Adjustment

(Fig G)

hib.co.uk