GREAT PLANES Big Stir 60 Руководство по эксплуатации - Страница 6

Просмотреть онлайн или скачать pdf Руководство по эксплуатации для Игрушка GREAT PLANES Big Stir 60. GREAT PLANES Big Stir 60 20 страниц.

❏ ❏

7. On the root rib there is a small hole. This is the hole

that the aileron servo wire will be fed through. Directly above

this hole make a 1/2" opening through the wing skin. This is

easily done with a Dremel

❏ ❏

8. Attach a clevis to one of the included pushrods. Tie

a loop onto a piece of string long enough to reach from the

servo bay to the hole you made in the wing skin. This string

will be used to assist pulling the servo wire through when we

get to the installation of the servos.

❏ ❏

9. Insert the pushrod through the hole in the root rib

until the clevis shows in the servo bay. Put the string onto

the clevis and pull the string back through the hole.

sanding drum.

❏ ❏

10. Pull the string out through the opening in the

bottom of the wing skin. Using masking tape, tape the string

to the wing at the servo bay and the hole you pulled the

string through. Taping the string in place will prevent it from

falling back into the wing.

❏

11. Repeat steps 7 - 10 for the other wing.

❏

12. Locate the three wood joiners. Draw a center line on

each of them. Trial fit them into both wing halves making

sure that the straight edge of the joiner is aligned with the

top of the wing. Once you are satisfied with the fit, apply

6-minute epoxy to 1/2 of the joiner and one pocket of one of

the wing.