GREAT PLANES Dazzler ARF Руководство по эксплуатации - Страница 6

Просмотреть онлайн или скачать pdf Руководство по эксплуатации для Игрушка GREAT PLANES Dazzler ARF. GREAT PLANES Dazzler ARF 20 страниц.

4. Make a mark on the center of the wing at the leading

and trailing edge.

5. Place the wing on the fuselage, aligning the marks you

made on the fuse and wing. Measure from the aft center of

the fuselage to one wing tip and record the distance.

Measure from the same point to the opposite wing tip and

compare it to the first measurement. If the measurements

are not the same, adjust the wig and re-measure until they

are equal.

6. Once the wing is properly positioned, turn the wing and

fuselage over and mark the location of the fuselage on the

top of the wing.

A = A

7. Cut away a 1/2" [13mm] strip of the film from the wing.

Be sure the cut is inside of the line. Important: Use only

enough pressure to cut through the film. Cutting into the

wing sheeting will weaken the strength of the wing.

8. Block the wing up off of the bench. Apply 6-minute

epoxy onto the wood where the covering has been cut away

and to the wood blocks. Place the fuselage onto the wing.

Place weight (bags of lead shot work well) onto the fuselage

to hold it in place on the wing and let the glue cure.

INSTALL THE STABILIZER

AND ELEVATOR

1. Cut away the covering from the openings in the fuselage

for the stab and fin.