ActiveAid 285 Руководство пользователя - Страница 9

Просмотреть онлайн или скачать pdf Руководство пользователя для Инвалидное кресло ActiveAid 285. ActiveAid 285 13 страниц.

Usage

Seat

Remove by lifting one corner at a time or lift off one side only and pivot the seat up from the opposite side

Install the seat by aligning opposite corners and snapping into place on the frame. Make sure that the seat is

square, and all 4 corners are snapped into place before sitting on chair.

Adjustable Sling Back

Loosen strap thru buckle to decrease tension, tighten strap thru buckle to increase tension.

Leg Rests

Gooseneck

Adjust the height of the footplate by depressing snap button and sliding footplate mount up or down to obtain

correct height. Remove leg rest assembly by lifting on the gooseneck to remove it from the receiver of the front

support.

Elevating Leg Rest

Adjust the height of the leg rest by depressing snap button and sliding footplate mount up or down to obtain

correct height. Adjust the angle of the leg rest upward by lifting, lower by depressing the tab.

Arm Rests

Height-Adjustable Arm Rests

To raise the arm, push up on the armlock cap and pivot back the entire armrest. To lower the arm, pull down on

the front of the armrest until the arm latch locks onto the securing stud under the arm pivot.

Flip-Up Arm Rests

To raise the arm up, pivot the arm lock lever away from the armrest and armrest lock. Lift up on the armrest.

Remove by depressing the snap button and sliding it out of the armrest pivot.

Tilt Function

Adjust the tilt-in-space angle position of the device by lifting on the lock release handle to disengage the locking

mechanisms. Lift up or push down on the handle of the back assembly to tilt the device to the position. Release

the lock release handle to lock and secure the device in place.

Head Support

Adjust height of headrest by loosening ratchet handle, sliding up and down, and re-tightening once desired

position is reached.

Adjust position of headrest by loosening the screws on the back with hex key (near the ball joint). Once in

preferred position, retighten the screws to hold in position.