GREAT PLANES fokker DR-1 Руководство по эксплуатации - Страница 7

Просмотреть онлайн или скачать pdf Руководство по эксплуатации для Игрушка GREAT PLANES fokker DR-1. GREAT PLANES fokker DR-1 20 страниц.

ASSEMBLE THE FUSE

❏

1. Locate two of the 3mm x 24mm [1/8" x 15/16"] dowel rods

and insert them into the bottom wing as shown, so that only

about 9mm [11/32"] sticks out. Secure them with medium CA.

❏

2. Test ﬁ t the bottom wing to the fuse and secure it with

two 3mm x 24mm [1/8" x 15/16"] machine screws and 3mm

[1/8"] washers. The ﬂ at side of the wing is the bottom.

Mount the Stab & Fin

❏

1. Using a sharp hobby knife, remove the covering from

the stab cut-out at the aft end of the fuse.

❏

2. Mark the center of the TE of the stab. Place the stab

onto the stab saddle.

❏

3. Stick a T-pin into the center of the top of the ﬁ rewall. Tie

a small loop in one end of a 900mm [35"] piece of non-elastic

string such as K&S #801 Kevlar thread. Slip the loop in the

string over the T-pin.

❏

4. Fold a piece of masking tape over the other end of the

string and draw an arrow on it. With the stab centered on the

fuse and the TE of the stab ﬂ ush with the aft end of the fuse,

slide the tape along the string and align the arrow with one tip of

the stab. Swing the string over to the same position at the other

end of the stab. If the arrow doesn't align with the tip, adjust the

stab and the arrow slightly and check both tips again. Adjust

the stab until the stab tips and the TE are centered.

❏

5. View the stab from approximately 3m [10'] behind the

plane. Check that the stab is parallel with the wing. If it is

not, lightly sand the stab saddle until the stab is parallel with

the wing.