GREAT PLANES XPD-8 Руководство по эксплуатации - Страница 12

Просмотреть онлайн или скачать pdf Руководство по эксплуатации для Игрушка GREAT PLANES XPD-8. GREAT PLANES XPD-8 16 страниц.

❏

5. Drill a 1/16" [1.6mm] hole through the fuse at an angle

for the receiver antenna as shown. When drilling the hole, be

sure your drill is angled enough to prevent drilling into the

duct channel.

❏

6. Feed the antenna through the hole to the underside of

the fuse. Use clear tape to secure the antenna to the

underside of the plane. Be sure that it does not interfere with

the elevons.

❏

7. Finish the model by gluing the intake ring to the front

of the duct channel.

GET THE MODEL READY TO FLY

❏

1. Turn on the transmitter and receiver and center the trims.

❏

2. Activate the elevon function on your radio. If you are

unsure how to do this, consult your radio manual.

❏

3. With the transmitter and receiver still on, check all the

control surfaces to see if they are centered. If necessary, adjust

the lengths of the pushrods within the heat-shrink tubing and

secure them again with CA glue.

❏

4. Make certain that the control surfaces and the throttle

respond in the correct direction as shown in the diagram. If

any of the controls respond in the wrong direction, use the

servo reversing in the transmitter to reverse the servos

connected to those controls. Be certain the control surfaces

have remained centered. Adjust if necessary.

Use a Great Planes AccuThrow (or a ruler) to accurately

measure and set the control throw of each control surface as

indicated in the chart that follows. If your radio does not have

dual rates, we recommend setting the throws at the low

rate setting.

Note: The throws are measured at the widest part of

the elevons.