Automated Pet Care Products LITTER-ROBOT Руководство - Страница 11

Просмотреть онлайн или скачать pdf Руководство для Средство для ухода за домашними животными Automated Pet Care Products LITTER-ROBOT. Automated Pet Care Products LITTER-ROBOT 18 страниц. Self-cleaning litter box
Также для Automated Pet Care Products LITTER-ROBOT: Руководство (16 страниц), Руководство пользователя (19 страниц)

Печатать страницу

Automated Pet Care Products, Inc.

will see that it is actually a threaded cylinder

with an extended lip at the top, called a T-nut.

The Cat Sensor sensitivity is adjusted by turning

this T-nut.

INCREASE SENSITIVITY

(If the cat is not triggering the Litter-Robot to cycle,

green light stays on):

Turn the T-nut one-half turn counter clockwise.

This will loosen the spring a little and make the

sensor more sensitive.

DECREASE SENSITIVITY

(If the green light won't come on, red light flashing)

Turn the T-nut one-half turn clockwise. This will

tighten the spring and make the sensor less

sensitive.

Now, you need to put it back together:

Put the loose wire harness back on, centering it over the

bolt as best you can. Replace the nut (flat side down)

and hand tighten. Hold the wire again while you finish

tightening the nut with a pliers or wrench.

You may have to adjust the sensitivity a few times until

you "tweak" it just right to the specific setting that

works for your cat.

If you need any assistance, call Customer Service

toll-free at 1-877-250-7729.

40 W. Howard, Suite B-5, Pontiac, MI 48342

Toll Free: 877-250-7729 Fax: 248-253-1797

www.Litter-Robot.com

Automated Pet Care Products, Inc.

Safety Features

Cat Re-Entry Protection Mode

If your cat tries to enter the Litter-Robot and activates

the Cat Sensor during a cleaning cycle, the Globe will

stop rotating. The Litter-Robot will wait for 15 seconds

and then attempt to resume the cleaning cycle. If the

Cat Sensor continues to be activated the Globe will not

turn.

The Cat Re-entry Protection is not active during

the Litter-Robot initialization cycle (first cycle

after plugging in the power cord). Do not leave

the Litter-Robot unattended during the

initialization.

Globe/Motor jammed or obstructed

If the Globe becomes jammed, the motor will stop and

all three lights on the Control Panel will blink at a rate of

twice per second.

Unplug the power cord

•

Remove the obstruction

•

Reposition the Globe in the home position

•

Plug the power cord back in. The Litter-Robot

will perform an initialization cycle.

If the condition persists, please call Customer Service,

toll-free at 1-877-250-7729.

40 W. Howard, Suite B-5, Pontiac, MI 48342

Toll Free: 877-250-7729 Fax: 248-253-1797