Automated Pet Care Products LITTER-ROBOT Руководство пользователя - Страница 10

Просмотреть онлайн или скачать pdf Руководство пользователя для Средство для ухода за домашними животными Automated Pet Care Products LITTER-ROBOT. Automated Pet Care Products LITTER-ROBOT 19 страниц. Self-cleaning litter box
Также для Automated Pet Care Products LITTER-ROBOT: Руководство (16 страниц), Руководство (18 страниц)

Печатать страницу

Testing the Cat Sensor

1. First, ensure that the Litter-Robot contains the right

amount of litter. The maximum litter level is about

2 inches below the lower rim of the entry opening.

2. Make sure that the green light on the Litter-Robot

Control Panel is on ("OK/Waiting").

3. If the red light is on ("Sensor/Timing"), push any of

the buttons (Cycle, Fill, or Empty). This resets the

unit and the green light should come on

("OK/Waiting"). Next, proceed to Step 4 of this

Testing procedure.

If the red light stays on ("Sensor/Timing"), the Cat

Sensor is too sensitive and needs to be adjusted.

To adjust the sensitivity of the Cat Sensor, see the

next section: "Adjusting the Cat Sensor Sensitivity".

40 W. Howard, Suite B-5, Pontiac, MI 48342

Toll Free: 877-250-7729 Fax: 248-253-1797

www.Litter-Robot.com

4. Next, with the green light on ("OK/Waiting"), gently

press down on the step with your hand until you

sense a slight displacement or tilt, then release (see

figures below). This should activate the Cat Sensor,

as indicated by the red light ("Sensor/Timing"). The

applied force represents your cat stepping on the

drawer. If the effort required to trip the Cat Sensor

is considerable, or you have noticed the sensor is

not activating when your cat enters the Litter Robot,

then the cat sensor is not sensitive enough and

needs to be adjusted. Skip Step 5 and go to the

next section that explains how to make these

adjustments.

Push down on step

with green light on

Green On

5. Now push any of the three buttons on the Control

Panel to reset the unit. If the green light comes

back on ("OK/Waiting"), the Cat Sensor is working

properly and you have successfully completed the

Sensor Test.

If the red light is still on ("Sensor/Timing"), the Cat

Sensor is too sensitive and needs to be adjusted.

The following section shows how to do this.

40 W. Howard, Suite B-5, Pontiac, MI 48342

Toll Free: 877-250-7729 Fax: 248-253-1797

www.Litter-Robot.com

Release step

Red On