Dynacord DMM 4650 Техническая информация - Страница 8

Просмотреть онлайн или скачать pdf Техническая информация для Музыкальное оборудование Dynacord DMM 4650. Dynacord DMM 4650 19 страниц. Signal processor

Печатать страницу

You have to perform a short test, speaking into the

microphone with a normal talking level and in an

appropriate distance. Whenever the display changes

from "<min" to "norm" the mic level is within the relevant

range.

Using the soft key "ok" the setting is being stored and

stays in memory (page 14).

In case the input level was too high and the indication

">max" has been displayed, you have to press the

"EXIT" button and follow the procedure once again from

the point where the record key was pressed. This time

the speaking distance to the microphone should be

increased; which results in a lower input level.

If the level was right ("norm" is shown on the display),

after pressing the "ok" key that the appliance is ready for

recording. The graphic bar in the lower line of the display

allows checking the input level. The Recorder is in the

pause-mode (ready to record).

Pressing the record button starts the recording.

The recording time gets displayed in m=minutes

and ss, s= seconds and the graphic bar offers

continuous verification of the actual input level.

Pressing the stop key terminates the recording

and the display shows the starting-menu

"message".

Pressing the button "start/stop" lets you control

your recording through the PHONES output.

If recording was not successful, you can give it

another try by pressing the "record" button. In this

case the display shows the message "delete?".

When you are sure that this is what you want, you

have to acknowledge the fact by pressing the

"yes" key.

The message 03 is being erased and a you can proceed with a new recording (RECORD key).

Recording quality and level setting only have to be re-adjusted if they were the cause for re-recording

the message.

To provide the new recording (message) with a new name, you have to follow these steps:

Press the soft key "edit".

In the display appears the sub menu "Message edit".

Using the soft key "ok", the system is ready to accept the

entry of a new name.

I<< << >¨ O >> >>I

Naming The Message, Title

recordlevel

test

<min!

recordlevel

test

recordlevel

test

recordlevel

EXIT

test

record M03

paused I========

record M03

m:ss,s I========

M03'Message ' vl

mm:ss.s

M03'Message '

delete?

M03'Message ' vl

mm:ss.s

Message edit

title

norm

>max

edt