GREAT WATER M1D2 Руководство по установке и эксплуатации - Страница 2

Просмотреть онлайн или скачать pdf Руководство по установке и эксплуатации для Диспенсер для воды GREAT WATER M1D2. GREAT WATER M1D2 8 страниц.

Печатать страницу

Programming and Installation Instructions

Thank you for choosing a Great Water product. Please read the following instructions carefully to

ensure a trouble free installation.

1. Planning The installation

• Always observe the relevant water regulations.

• Make sure your selected location allows sufficient space and access for salt filling and

maintenance.

• Make Sure your mains water pressure is within the specified parameters of 1.5 – 5 Bar. If the

daytime pressure exceeds 3.5 Bar then we recommend a Pressure limiting valve be installed

to 5 Bar

• Identify how and where you will be able to run your waste and overflow connections

• Identify your available power source.

The water softener should be installed as per the diagram below.

SOFT WATER

Bypass Valve

(shut)

Check Valve

Hard Water

Supply

Notes

a. Keep the distance to the drain as short as possible and ensure that the drain and overflow

connections are not subject to freezing.

b. If siting the softener in a cupboard or in a loft ensure that the base is flat strong enough and

adequately supported for the weight of the water softener including salt (approx. 40kg)

c. If the softener is to be sited in a loft it is strongly recommended that the softener be housed

within a 25 gallon storage (safety) tank with a minimum ¾" overflow connection. It is essential

that the overflow connection be as low as possible on the safety tank and in any event below

the height of the overflow connection from the water softener.

d. Check valve. Domestic ion exchange water softeners are considered a Fluid category 2 risk.

Therefore a type EA or EB single check valve should be fitted to the pipework immediately

before the tee feeding the water softener as a suitable backflow prevention.

e. Drinking Water – it is recommended that a hard water supply be used for the kitchen cold

drinking water and any outside taps.

TO SERVICE

Inlet and Outlet

Flexible Hoses

Outlet Valve

(open)

Inlet Valve

(open)

Pressure Limiting

Valve (if required)

STOP TAP ON

INCOMING MAIN

Power

Drain Hose

CONTROL

VALVE

Drain Clip

Overflow

hose

through

SALT

outside

STORAGE

wall

TANK

Trapped

Upstand OR

run drain

hose to

external gully

20mm

air gap