DynaGen AST2225 Руководство по установке и эксплуатации - Страница 11
Просмотреть онлайн или скачать pdf Руководство по установке и эксплуатации для Переключатель DynaGen AST2225. DynaGen AST2225 19 страниц. Automatic transfer switch
Печатать страницу11
4: RECOMMENDED MAINTENANCE
The AST2225-3 transfer switch assembly has been designed to require minimum
attention under all environmental conditions normally encountered. All sliding and
bearing surfaces are inherently self-lubricating due to the combination of materials used
and therefore should not be lubricated, thus preventing any accumulation of dust and grit
at these locations. The gear-motor is also lubricated for the life of the unit, and requires
no attention.
Periodically inspect all terminals (load, line and control), and all fasteners for tightness.
Test the transfer switch operation upon initial installation, in both the motor and manual
modes. Periodically check for freedom of movement of the mechanism, hidden dirt or
corrosion, and any excessive wear on the mechanical operating parts. Clean or replace
parts when necessary.
Do not attempt to remove the arm assembly by loosening the pivot screw and lock nut.
Instead, remove the four screws holding the pivot bracket in position and lift the
assembly clear. This will facilitate any adjustment of the pivot screw and lock nut that
may be required after extended service.
Automatic
Manual for AST2225 Series
Transfer Switch