DynaGen ES53 Руководство по установке и эксплуатации - Страница 6

Просмотреть онлайн или скачать pdf Руководство по установке и эксплуатации для Блок управления DynaGen ES53. DynaGen ES53 18 страниц. Control module

WIRING INSTALLATION GUIDELINES

Danger: Never work on the engine while its power is on. This

controller does not generate a warning signal prior to automatic engine

start. Warning signs should be placed on engine equipment indicating

this important safety measure.

Following these instructions will help avoid common installation problems during wiring and

setup.

• Battery must be disconnected before any wiring connections are made.

• Wire length from the engine to the controller should not exceed 6 meters (20 feet).

Wiring size and type should be as specified below. Use stranded wire, since solid wire has a

tendency to crack, break and loosen over time.

Terminal

Wire Size

CON 1

supplied

13 ⇒ 17

Installation and User Manual for the ES53 Control Module

INSTRUCTIONS

TYPES AND SIZES

Current max.

Harness

100mA

7mA

10 A

20 A

10 A

300mA

Function

Speed signal connection via on board

connector

LED test switch

Oil pressure switch

High Temperature switch

Auxiliary Input switch

Starter solenoid/pilot relay

Battery negative (-)

Auto switch

RSC1 (remote start contact connection)

RSC2 (remote start contact connection)

Start/Stop connection

Fuel solenoid/pilot relay

Timer output

Annunciation outputs

Normal Disable

Emergency Disable

Ground connection