DayTronic IL70A Руководство

Просмотреть онлайн или скачать pdf Руководство для Блок управления DayTronic IL70A. DayTronic IL70A 15 страниц. In-line dc strain gage conditioner

IL70A

IN-LINE DC Strain Gage Conditioner

ENERAL

The Model IL70A is a single-channel instrument which is easily configured, rugged, analog based

signal conditioner made to operate with traditional Wheatstone mv/V stain gage bridge sensors

used to measure force, pressure, torque and other DC strain gage related measurements. The Model

IL70A has an extremely wide DC power input range with user selectable gain, zero and anaolg output

making it adaptable to any users sensor application that requires stable, repeatable and noise free

analog signals for control or data acquisition.

The Model IL70A is best calibrated by means of a "two-point (dead-weight)" or shunt-calibration

technique, which is outlined in section three. The supplied calibration resistor is 59 kilohms, 1%

which is located internally to the IL70A pcb circuit.

Shunt Operation:

selection. "EXT" is for an external - user installed shunt or "INT" for the internal - built in - 59K Ohm shunt. Installing the jumper

enables the selected feature. For an external shunt resistor, install the leaded resistor between the "Cal Sense" (pin 7) terminal

and either the + Signal (pin 5) or the - Signal (pin 6) terminals. Use the SW4 "Shunt" button to engage the shunt resistor across

the selected side of the bridge or "SHP or "SHN" logic input lines. For transducers with an installed shunt resistor, place the

jumper on the "EXT" teminals and wire the "Cal Sense" line to the transducer's shunt connector pin.

DC Strain Gage Symmetry Operation:

torque cells), the IL70A contains a symmetry adjustment which corrects for negative span or slope of the transducer.

92375.00 rev. B

ESCRIPTION AND

Top View of the Model IL70A DC Strain Gage Module (cover removed)

Located between the two screw terminal connectors, the IL70A contains a Shunt resistor jumper

For applications requiring precision in both tension and compression (CW & CCW for

ODEL

DC Strain Gage

ONDITIONER

PECIFICATIONS

GENERAL DESCRIPTION AND SPECIFICATIONS

IL70A

Module

IL70A.1