Automatic Technology Megacode Tricode 128 Руководство - Страница 9

Просмотреть онлайн или скачать pdf Руководство для Приемник Automatic Technology Megacode Tricode 128. Automatic Technology Megacode Tricode 128 20 страниц. Multi-frequency four channel receiver

Печатать страницу

Automatic Technology Megacode Tricode 128 Руководство

5. Remotely Coding Transmitters

Fig 5.1

Fig 5.2

Fig 5.3

Fig 5.4

REPLACE BATTERY WITH CR2032 ONLY

PRESS

Existing

transmitter

Existing

transmitter

PRESS

New

transmitter

Use a pen

to push the

battery down

through the

side opening

to release

battery

If a TrioCode™128 transmitter is already coded into the MegaCode

receiver, additional TrioCode™128 transmitters can be coded without

being in direct contact with the MegaCode

NOTE: Only the function of the existing transmitter button can be

assigned to new transmitter. Please read instructions prior to proceeding

- there is a time-out facility for security reasons.

5.1 Selecting The Function To Be Coded

Using the existing transmitter, operate the MegaCode

with the transmitter button which has the function to be coded

(e.g. Button 1 has been coded with the M_1 function assigned).

5.2 Activate Remote Code Set Mode

Using this method transmitters can be coded without access to the

opener's control panel as long as a pre-coded transmitter is available.

a. Take any pre-coded transmitter. Press the button for the function to be

duplicated and release.

b. Using a small needle / pen, press and hold firmly for two seconds the

middle button, through the Coding Hole

c. Within ten (10) seconds take the additional transmitter you wish to

code. Hold the new transmitter's button for two seconds, pause for

two seconds, hold again for two seconds and then release

d. Wait for ten (10) seconds and then press the new transmitter's button

to test.

NOTE: When a transmitter is remotely coded, its ID label is set to that

of the existing transmitter. If the existing transmitter does not have an ID

label assigned, then the ID label of the new transmitter is set to: R/C Tx

###, where ### is the existing transmitters store number. This ensures that

the originator of any remotely coded transmitter can be identified.

5.3 Removing the Battery From the Transmitter

(Battery Type: 3V Lithium Battery CR2032).

Use a non-metallic object (e.g. pen) to remove the battery.

test the battery is working, press and hold a transmitter button;

(Fig. 5.5).

Light Status

Battery Status

Solid

Flashing

Requires replacement

No light

Requires replacement

Fig 5.5

Installation Instructions MegaCode

receiver.

receiver's output

(Fig. 5.1)

(Fig.

5.2).

(Fig.

5.3).

(Fig. 5.4).

Receiver