Dynalabs DYN-G-6000 Руководство по эксплуатации - Страница 7
Просмотреть онлайн или скачать pdf Руководство по эксплуатации для Краскопульт Dynalabs DYN-G-6000. Dynalabs DYN-G-6000 8 страниц.
Печатать страницуAll rights reserved. Reproduction or issue to third parties in any form whatsoever is not permitted without written authority from the proprietors.
3) Operation and Installation
3.1) General
The general sensor connector configuration is given below;
Cable Code/Pin Configuration:
• Red
: V +
• Black
: Ground
• RX : Yellow
: Gyro Signal
WARNING
Never connect the power supply and/or the power ground to yellow cables.
Never connect the power supply to the power ground. Always use a clean power
source and check the voltage range.
Power supply voltage +5 V to +20 VDC.
Power GND
Single-ended analog output voltage signal
7