80% Arms FST-1 Руководство по эксплуатации - Страница 9

Просмотреть онлайн или скачать pdf Руководство по эксплуатации для Электроинструмент 80% Arms FST-1. 80% Arms FST-1 12 страниц.

Печатать страницу

OPERATION

DEPTH OF CUT

See Figure 5

Depth of cut affects the rate of feed speed and



the quality of a cut. Using the proper depth of cut can

lessen the possibility of damage to the router motor and

cutter.

A deeper cut requires a slower feed than a shallow



one. Making a cut that is too deep will slow the feed

so that the cutter is scraping, rather than cutting,

and is not recommended.

A too-deep cut can cause chatter and cutters to



be broken off. Attempting a cut that is too deep will

result in a

rough

cut,

guide

and control the cutter as desired. Do not

exceed 1 hash mark depth of cut in a single pass. For

best finish quality, do not exceed 1/2 hash mark depth

of cut on our Easy-Jig® line of jigs. This will result in a

higher quality finish.

WARNING:

Do not exceed more than 1 hash mark in a single

pass. Excessive depth of cut can result in loss of

control and the possibility of damage to your

cutter, lower, jig, and can cause serious personal

injury.

SETTING DEPTH OF CUT

 Unplug the router.

 Pull open the quick release Locking Lever "D".

 Turn the depth Adjusting Screw "F" to slide the

motor housing and cutting tool up and down to the

desired hash mark depth.

 Close the quick release Locking Lever "D".

CAUTION:

Failure to properly adjust the locking lever tension

nut can result in the base slipping when using the

router, resulting in property damage and possible

personal injury. Please follow ADJUSTING TOOL

BASE LOCKING LEVER directions on page 6 prior

to using the router.

and

may

make

difficult

 The cutter depth can be read on the depth scale on the

motor housing. Do not exceed 0.05" or 1.3 mm. Each

mark on the inch scale indicates a 0.05" change in depth

setting. Use the depth gauge on your Easy-Jig® when

setting the depth of cut.

 When the desired depth of cut is reached. Push the

quick release lever to the closed position to lock the

cutter in place.

 Before use, always check that the quick release locking

lever nut tension is properly set so that the base does

not accidentally slip while milling, causing the depth of

cut to change, and possible damage to the lower and

cutting tool.

WARNING:

Make sure the quick release locking lever is

properly adjusted and securely locks the motor

housing to the removable base. Damage to your

cutter, lower receiver, jig and serious personal

injury can result from using a router with a loose

quick release locking lever.