Celestron 22151 Руководство по эксплуатации - Страница 3

Просмотреть онлайн или скачать pdf Руководство по эксплуатации для Телескоп Celestron 22151. Celestron 22151 9 страниц.

ASSEMBLING YOUR TELESCOPE

THE MOUNT

The Omni XLT AZ mount and tripod come fully assembled,

so setting it up is easy.

1. Remove the tripod and mount from the box.

2. Loosen the hand knobs at the bottom of each leg and

extend the inner section of the leg to the desired length.

Tighten the knobs to secure the legs, being careful not

to over tighten.

3. Stand the tripod upright and pull the tripod legs apart

until the center brace snaps into place.

4. Place the accessory tray on top of the center brace and

line up the holes. Insert the three thumb screws through

the bottom of the leg brace and thread them into the

tray.

5. Make sure the leg hinge bolts are secure by snugging

down the black thumbnuts at the top of each leg.

ADJUSTING THE ANGLE OF THE MOUNT ARM

Depending on your speciﬁ c use of the telescope, you may

wish to change the angle of the mount arm to give you

additional range of motion. The mount comes set up for

the astronomical use; it can move upward but is limited

in its downward motion. If you are using the mount for

terrestrial observation from an elevated location (cliff top,

balcony, etc.) and you want to point the scope well below

the horizon, you will need to change the angle of the mount

arm to accommodate this.

To make this adjustment:

1. Unthread the round cover on the bottom of the vertical

arm of the mount.

2. Using a 4 mm hex-key wrench (user supplied), remove

the three screws under the cover.

3. Rotate the mount arm so that it is pointed straight up and

thread the three screws back in.

4. Tighten the screws and replace the round cover.

ENGLISH |