Gree AEH18AA-D3DNA1C/I Руководство по установке и эксплуатации - Страница 3
Просмотреть онлайн или скачать pdf Руководство по установке и эксплуатации для Кондиционер Gree AEH18AA-D3DNA1C/I. Gree AEH18AA-D3DNA1C/I 15 страниц.
Печатать страницуPart names and their functions
INDOOR UNIT
CAUTION
Before opening the front panel, be sure to
stop the operation and turn the breaker OFF.
Do not touch the metal parts on the inside
of the indoor unit, as it may result in injury.
1. Titanium Apatite Photocatalytic
Air-Purifying Filter:
These filters are attached to the inside
●
of the air filters.
2. Air outlet
3. Display
4. Front panel
5. Louvers (vertical blades)
The louvers are inside of the air outlet.
●
6. Air inlet
7. Air filter
8. Flap (horizontal blade)
9. Cool mode lamp
10. Heat mode lamp
11. Dry mode lamp
12. Run lamp
13. LED display
14. Indoor Unit ON/OFF switch:
Push this switch once to start operation.
●
Push once again to stop it.
The operation mode refers to the following table.
●
Model
Mode
COOLING
AUTO
ONLY
HEAT
AUTO
PUMP
This switch is useful when the remote controller
●
is missing.
15.Signal receiver:
It receives signals from the remote controller.
●
When the unit receives a signal, you will hear
●
a short beep.
Settings changed.....beep
●
16.Air outlet selection switch
17.Room temperature sensor:
It senses the air temperature around the unit.
●
NOTE:
① If the supply cord is damaged, it must be replaced by the manufacturer or its service agent or a similarly qualified person in order to avoid a hazard.
② The appliance shall be installed in accordance with national wiring regulations.
③ An all-pole disconnection switch having a contact separation of at least 3mm in all poles should be connected in fixed wiring.
9
10
14
Temperature
Air flow rate
setting
25℃
AUTO
25℃
AUTO
3
8
11
12
13
7
4
15
2
Air outlet selection switch
•
This setting blows air from
16
upper outlet only.
•
This setting automatically
decides a blow pattern
depending on mode and
conditions.
•
This setting is recommended.
•
The unit is shipped from the
factory with this setting.
Indoor unit
wiring terminal
N(1) 2
3
green
white
red
black
(yellow-
(brown)
(blue)
green)
Outdoor unit connection
1
OPERATION INSTRUCTIONS
1
2
5
Opening the Front Panel
6
17