Celestron PowerSeeker 70AZ Руководство по эксплуатации - Страница 6

Просмотреть онлайн или скачать pdf Руководство по эксплуатации для Телескоп Celestron PowerSeeker 70AZ. Celestron PowerSeeker 70AZ 10 страниц.

Печатать страницу

Celestron PowerSeeker 70AZ Руководство по эксплуатации

SSembly

This section covers the assembly instructions for your

PowerSeeker telescope. Your telescope should be set up

indoor the first time so that it is easy to identify the various

parts and familiarize yourself with the correct assembly

procedure before attempting it outdoor.

Each PowerSeeker comes in one box. The pieces in the

box for all models are – optical tube, altazimuth mount,

and "The SkyX" CD-ROM. The 40AZ and 50AZ includes

eTTing uP The

riPod

1. Remove the tripod from the box (Figure 2-1). The tripod

comes preassembled so that the set up is very easy.

Each tripod is different for each model but looks

somewhat similar to the photos shown below.

2. Stand the tripod upright and pull the tripod legs apart

until each leg is fully extended and then push down

slightly on the tripod leg brace (Figure 2-2). The very top

of the tripod is called the tripod head (AZ mount).

3. Next, we will install the tripod accessory tray (Figure 2-3)

onto the tripod leg brace (center of Figure 2-2).

4. On the bottom of the tripod tray is a screw attached to

the center (except the 40AZ and 50AZ). The screw

attaches into a threaded hole in the center of the tripod

leg brace by turning it clockwise – Note: pull up slightly

on the tripod leg brace to make it easy to attach.

Continue turning the tray until hand tight – don't over

tighten the tray. The 50AZ is slightly different as you

unthread a small knob in the center of the tray (see

Figure 2-3a) and then put the tray over the threaded

hole and tighten the knob to secure the tray.

5. The tripod is now completely assembled

(Figure 2-4).

6. You can extend the tripod legs to the

height you desire. At the lowest level,

the height is about 27" (69 cm) and

extends to about 47" (119 cm). You unlock

the tripod leg lock knobs at the bottom of

each leg (Figure 2-5) by turning them

counterclockwise and pull the legs out to

the height you want and then lock the

knobs securely. A fully extended tripod

looks similar to the image in Figure 2-6.

7. The tripod will be the most rigid and stable

at the lower heights.

0.96" accessories – 20 mm eyepiece, 12 mm eyepiece

(50AZ only), 8 mm eyepiece (40AZ only), 4mm eyepiece

(50AZ only), 3x Barlow lens (2x Barlow with 40AZ), and

1.5x erecting eyepiece. The 60AZ, 70AZ and 76AZ

includes 1.25" accessories – 20 mm eyepiece (erect image

for 76AZ), 4 mm eyepiece, 3x Barlow lens, erect image

diagonal for 60AZ.

2-1

igure

2-4

igure

2-3

igure

2-5

igure

2-2

2-3

2-6

igure