ADEMCO 5707 Руководство по установке - Страница 5
Просмотреть онлайн или скачать pdf Руководство по установке для Дымовая сигнализация ADEMCO 5707. ADEMCO 5707 12 страниц. Smoke detector with built-in wireless transmitter
Печатать страницу
TESTING
THE SMOKE
DETECTOR
The following
procedure
should be performed
after installation
is completed.
THIS TEST SHOULD
ALSO BE PERFORMED
ON A REGULAR
BASIS (AT
LEAST WEEKLY) BY THE USER.
1. Activate the wireless system's test mode.
2. Press and hold down the smoke detector's
TEST button and observe
the
following:
a) Wtihin 15 seconds, the detector's horn should sound.
b) The smoke detector
should begin transmitting
alarm signal
(every
12
seconds) to the receiver, and the console should emit 3 tones each time a
signal is received.
The detector's ID number should also be displayed on
the console.
3. Release the TEST button.
The audible alarm from the detector will continue
for up to 10 seconds.
Approximately
1 second after the horn stops, the ID
number should disappear from the console display.
TO THE INSTALLER
Regular maintenance
and inspection
(at least annually) by the installer and
frequent testing by the user are vital to continuous
satisfactory
operation
of
any alarm system.
The installer should assume the responsibility
of developing
and offering a
regular maintenance
program to the user as well as acquainting
the user
with the proper
operation
and limitations
of the alarm
system
and its
component
parts.
Recommendations
must be included
for a specific
program of frequent testing (at least weekly) to insure the system's propar
operation at all times.
SUMMARY OF DETECTOR FUNCTIONS
LED
HORN
STATUS
Flashes every 7
Silent
Normal, functioning
seconds
properly
Flashes every 7
Beeps once every
Low battery or detector
seconds
15 seconds
malfunction
On steadily
On continuously
Alarm, detecting smoke
BATTERY
REPLACEMENT
The smoke detector's
batteries
should be changed
within 7 days following
a
"LOW BAITERY"
message at the console.
The smoke detector itself will also
provide a low battery indication
by producing
a beep once every 15 seconds.
Duracell MN 1604 alkaline batteries are the only acceptable
batteries for use in
this product. When replacing weak batteries, be sure to replace BOTH batteries
with fresh ones.
1.
2.
Remove
the smoke
detector
from
its mounting
bracket
by pressing
the
release tab (marked PRESS) and pivoting away from and off the bracket.
Remove the old batteries
and install two fresh Duracell
MN 1604, 9-volt
alkaline
batteries
in their
correct
positions
in the
detector's
battery
compartment
(see
BATTERY /NSTALLAT/ON in a
previous sdcm).
Be sure
–5–