HIDRO-DOMESTICS 1RM 2 37 Series Руководство по установке - Страница 8
Просмотреть онлайн или скачать pdf Руководство по установке для Открыватель ворот HIDRO-DOMESTICS 1RM 2 37 Series. HIDRO-DOMESTICS 1RM 2 37 Series 11 страниц.
Печатать страницуGENERAL SAFETY REQUIREMENTS
This instruction manual is intended solely for use by qualified professionals.
The installation, electrical connections and adjustments must be made in accordance with the current legislation in each country.
Carefully read the instructions before starting to install the equipment. Incorrect installation can be dangerous.
Packing material (Plastic, expanded polystyrene, etc.) should be disposed of without causing environmental damage and should be kept out of the
reach of children, as it is potentially dangerous.
Do not install electrical equipment in an explosive environment or atmosphere. The presence of gas or inflammable fumes represents a severe
security risk.
Before installing the equipment, make all necessary modifications to the door/gate to ensure that there is no risk of crushing, cutting or any other
possible movement that could cause harm.
The manufacturer of the equipment is not responsible for the automated door/gate not meeting the relevant safety standards, nor for the possible
deformations that could occur during use.
Safety devices (photo-electric cells, pneumatic strips, etc.) should be installed in accordance with the current safety standards. These safety devices
should be installed such as to avoid any possible crushing, cutting or danger in general by the door/gate that is being automated. Apply the relevant
warning sings as per the current standards to indicate the potential danger areas.
Each installation should have clearly visible identification information of the automated door/gate.
Install a two-pole switch at the power supply to turn off the supply in case of emergency.
Check that there is a differential and thermal cut-out.
Always earth the equipment and the door/gate.
MACHINERY DIRECTIVE
According to the Machinery Directive (2006/42/EC) The installer of a door/gate has the same obligations as the manufacturer of a machine and, as
such, must :
Create a technical report for the motorised door/gate which must include the documents specified in Appendix V of the Machinery Directive.
(This technical record should be conserved and made available to the relevant national authority for at least ten years from the date of
manufacture of the motorised door/gate.
Produce the CE conformity declaration for the motorised door/gate as per Appendix II-A of the Machinery Directive.
Put the CE mark on the motorised door/gate as per clause 1.7.3 of Appendix I of the machinery Directive.
MANUFACTURER DECLARATION
(
Directive 2006/42/CE, Appendix II, part B)
Manufacturer: Hidro – Domèstics, S.L.
Address: C/ Fusteria, 26, 28, 30, 08551 Tona Barcelona – SPAIN
Declares that the systems with part numbers: 1RM2D37, 1RMT2D37, 1RM2RT37 y 1RMT2RT37.
Are built to be used in a machine or to assemble with other machines to build a machine considered by the Directive 2006/42/CE, as modified.
-
Conform to the conditions of the following CE Directives:
-
Electro-magnetic compatibility Directive 89/336/CEE, as modified.
Low tension directive 2006/95/EC, as modified.
Safety standard for hydraulic transmission systems EN-ISO 4413:2010.
And also declares that it is not permitted to use the machinery until such time as the machine in which it is to be used, or of which is component part,
has been declared in conformity with the conditions of the directive 2006/42/CE and any relevant national legislation.
Tona a 12/05/03
- 8 -
Jordi Roquet
(Director )