Celestron 47005 Руководство по эксплуатации

Просмотреть онлайн или скачать pdf Руководство по эксплуатации для Погодная станция Celestron 47005. Celestron 47005 15 страниц. Personal weather station with wireless remote sensor

Печатать страницу

Personal Weather Station with

Wireless Remote Sensor

Model # 47005

Thank you for purchasing this Celestron personal weather

station. Please read the instructions prior to using it and we hope

you will have many years of pleasure with it.

Set Up Power for the Receiver

For optimum performance, please place the Receiver away from metal and other sources of

interference such as mobile phones, TVs, computers, appliances, etc. If the Receiver stops showing

the display or dims, replace the batteries.

The Receiver can be put on a table, desk, or other flat surface or it can (by using a

hanger cut out on the rear of the Receiver) be hung on a wall or other location. For

using on a flat surface the small base piece is to be inserted at the bottom of the

Receiver by pushing the two protruded pieces into the open slots on the bottom of

the Receiver until secure. The correct position of the base is shown in the image to

the right.

Set Up the Power & Make Settings for the Wireless Remote Sensor

Remove the four small screws (center right image) from the rear door of the sensor with a small

screwdriver (remove the bracket first). Insert two AAA batteries (user supplied) as indicated in the

sensor (see right image). Set the switch to "1" (for Channel 1), push/toggle the button so readings will

be shown in "C" (Centigrade) or "F" (Fahrenheit). Then push the button "TX" and hold it a couple of

seconds which will transmit the RF signal from the Sensor to the Receiver. The Sensor itself will

display the outside temperature and humidity (see left image). Replace the rear door of the sensor by

installing the four small screws to hold it in place.

The Sensor can be mounted up to 100 feet (30 meters) in an open area from the Receiver to

communicate with it. The Sensor has a place on the rear of the unit to mount/hang it securely (hanger

part on left of center image) to any surface that is secure or it can stand by itself (if in an area without

wind, etc. by using the included stand bracket (center left image).

Open the battery compartment door on the rear of

the Receiver. Then insert two AA batteries (user

supplied) with polarity as indicated in the battery

compartment. After installation, put the battery

compartment door back on. If battery power is

low, a low battery icon will be shown on the

LCD display alerting you to change the batteries.