Automotive Tazer JL Mini Руководство пользователя - Страница 6
Просмотреть онлайн или скачать pdf Руководство пользователя для Диагностическое оборудование Automotive Tazer JL Mini. Automotive Tazer JL Mini 14 страниц. For jeep wrangler jl & gladiator jt 2018-2020
Печатать страницуThe setup menu is accessed with the ignition ON but engine NOT running.
The menu items are listed in the order in which they will display.
• Light Shows: Activate pre-programmed
and custom light shows, even when the
engine isn't running.
• Clear CELs: Clear the check engine
light and diagnostic codes stored in the
PCM, TCM, ABS, and AWD modules.
• Display DTCs: Cycles through
Diagnostic Trouble Codes
• Marry/Unmarry:
of the vehicle settings, you will first
need to "Marry" the Tazer JL Mini
to the vehicle.
option, the Tazer JL Mini will download
your car's current (presumably stock)
settings. This should take around 15
seconds. Do not disturb this process.
Once complete, you will be able to
advance to the Settings choices.
Submenu Perf:
performance-based options
• Set Tire Size: Use this setting to change
the calibration for tire size. Use the left
arrow and cruise +/- buttons to raise or
lower the value, then select it (left arrow
and cruise on/off) to save the new setting.
• Set Gear Ratio: Use this setting to change
the calibration for axle gear ratio. Use the
left arrow and cruise +/- buttons to raise
To advance to any
When you select this
• Submenus: Once married, you can
advance though several sub-menus.
Select a submenu using the method
described above.
Select "UNMARRY" to
return the vehicle to stock.
After unmarrying, advance to the "full
reboot?" option and select it, allowing a
full 2.5 minutes for the Tazer JL Mini to
reboot all systems – the Uconnect will
reboot twice in this time, the dash will
reset, and when it's finished, the red
security dot on the dash will turn on and
back off.
A few sleep cycles might be
required for all changes to take effect.
or lower the value, then select it (left arrow
and cruise on/off) to save the new setting.
• Set Transfer Case LOW ratio: Use this
setting to change the calibration for 4LOW
gear ratio. Use the left arrow and cruise
+/- buttons to raise or lower the value,
then select it (left arrow and cruise on/off)
to save the new setting.
6