2gig Technologies 2GIG‐SMKT3‐345 Инструкции по установке - Страница 2
Просмотреть онлайн или скачать pdf Инструкции по установке для Дымовая сигнализация 2gig Technologies 2GIG‐SMKT3‐345. 2gig Technologies 2GIG‐SMKT3‐345 2 страницы. Wireless smoke/heat/freeze alarm
Печатать страницуNFPA Recommended Locations for Alarm
According to the National Fire Protection Association (NFPA) the major threat from fire in a
dwelling unit occurs at night when everyone is asleep. The principal threat to persons in
sleeping areas comes from fires in the remainder of the house; therefore smoke alarms are
best located between the bedroom areas and the rest of the house.
Where NOT to install the Alarm
•
Directly above a sink, cooker, stove or oven
•
Do not locate alarm within 5 feet (1.5 m) of any cooking appliance
•
Next to a door or window that would be affected by drafts (extractor fan or air vent)
•
Outside
•
In or below a cupboard
•
Where air flow would be obstructed by curtains or furniture
•
Where dirt or dust could collect and block the sensor
•
Where it could be knocked, damaged, or inadvertently removed
Do NOT INSTALL this alarm in a location where the normal ambient temperature is
below 40 F (4.4 C) or where it exceeds 100 F (37.8 C)
INSTALL this equipment in accordance with the National Fire Protection Association (NFPA) 72.
Maintenance
Clean the alarm once a year. To clean the alarm, remove it from the mounting base. You can
clean the interior using compressed air or a vacuum cleaner. Blow or vacuum through the
openings around the perimeter of the alarm. The outside of the alarm can be wiped with a
damp cloth. After cleaning, test the alarm by pushing the Test button. If cleaning does not
restore the alarm to normal operation you need to replace the alarm.
WARNING: READ THE FOLLOWING CAREFULLY
•
NFPA 72 states: Fire‐warning equipment for residential occupancies are capable of
protecting about 50% of the occupants in potentially fatal fires. Victims include the
elderly, children, and the physically or mentally impaired. Victims include any person
that cannot escape even when warned early enough that escape should be possible. For
these people, other strategies such as protection‐in‐place or assisted rescue or escape
would be necessary.
•
Studies show that Smoke/Heat Alarms may not awaken all sleeping individuals. It is the
responsibility of individuals in the household that are capable of assisting others to
provide assistance to those who may not be awakened by the audible alarm or those
who may be incapable of safely evacuating the area unassisted.
•
A battery‐powered alarm must have the specific battery type installed, be in good
condition, and be mounted properly.
•
The use of alcohol or drugs may also impair one's ability to hear the audible alarm. For
maximum protection, ensure that an audible alarm is installed on every floor of the
home.
•
Smoke/Heat Alarms only provide protection to the residence if smoke actually reaches
the alarm. The Smoke/Heat Alarm is not a substitute for an insurance policy.
Home owners and renters should have adequate insurance to protect their properties.
Safety Tips
•
Make a Family Escape Plan. Draw a map of your home showing all doors and windows.
Discuss the plan with everyone in the home.
•
Know at least 2 ways out of every room, if possible. Make sure all doors that lead to the
outside of home open easily.
•
Have an outside meeting place, like a light pole, mailbox, or tree a safe distance from the
residence where everyone meets.
•
Practice your Family Escape Plan or "Fire Drill" at night and during the day at least twice a
year. Only practice when every member of the house can attend.
•
Practice using different ways out, if possible.
•
Teach your children how to escape on their own in case you cannot help them.
•
Close doors behind you as you leave.
Family Escape Plan
According to the National Fire Protection Association (NFPA) there often is very little
time between the detection of a fire and the time it becomes deadly. This interval can be
as little as 1 minute. Planning and practicing for fire conditions with a focus on rapid exit
from the residence are important! Fire drills should be held so that all family members
know the action to be taken.
If the Alarm Sounds
• Get out and stay out. Never go back inside for people or pets.
• If you have to escape through smoke, get low and go under the smoke.
• Call the fire department from outside your home.
FOR MORE SAFETY INFORMATION SEE: www.nfpa.org/education
Specifications
Transmitter Frequency
345.00 MHz (crystal controlled)
Transmitter Frequency Tolerance
+ ‐15 kHz
Transmitter Bandwidth
24 kHz
Modulation Type
Amplitude Shift Keying‐On/Off Keying (ASK‐OOK)
Unique ID Codes
Over 1 billion different code combinations
Supervisory Interval
70 minutes
Dimensions
.5" x 2.5" high (125 mm x 63 mm high)
Weight (including batteries)
8.57 oz (243 g)
Color
White
Spacing Rating
70 ft
Audible Signal (ANSI Temporal 3)
85dBA min. in alarm
Sensitivity
.5 ‐ 3.5%/foot
Max Current
50mA
Alarm Current
20mA
Supervisory Current
25uA
Operating Temperature
40°‐100 F° (4.4°‐37.8° C)
Relative Humidity
15‐90% Non‐Condensing
Batteries (included)
3 AAA Energizer E92 or equivalent
Regulatory Listing
UL 217
Warranty
2 years
Included Accessories
Mounting Hardware Package
Regulatory Information
This device complies with Part 15 of the FCC's Rules. Operation is subject to the following
two conditions:
1
This device may not cause harmful interference, and
2
This device must accept any interference received, including interference that may
cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following
measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and receiver.
•
Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
•
Consult the dealer or an experienced radio/TV technician for help.
This product complies with FCC radiation exposure limits for an uncontrolled environment.
Avoid operating this product at a distance less than 20 cm from the user.
Caution: Any changed or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate this equipment.
IC approval
This device complies with Industry Canada license‐exempt RSS standard(s). Operation is
subject to the following two conditions: (1) this device may not cause interference, and (2)
this device must accept any interference, including interference that may cause undesired
operation of the device.
RÉGLEMENTATION IC: Cet appareil est conforme avec Industrie Canada exempts de license
standard RSS (s). L'opération est soumise aux deux conditions suivantes: (1) cet appareil ne
peut causer d'interférences, et (2) cet appareil doit accepter toute interférence, y compris
les interférences qui peuvent causer un mauvais fonctionnement du l'appareil.
Cet équipement est conforme aux limites IC exposition au rayonnement pour un
environnement non contrôlé. Cet équipement doit être installé et utilisé avec distance
minimum de 20cm entre l'utilisateur et l'élément rayonnant de l'appareil.
Remarque: le fabricant n'est pas responsable des interférences radio ou télévision causé par
des modifications non autorisées de cet équipement. Une telle modification pourrait
annuler l'autorité de l'utilisateur d'exploiter cet équipement.
This Class B digital apparatus complies with Canadian ICES‐003
Cet appareil numérique de classe B est conforme Ia á norme NMB‐003 du Canada.
LIMITED WARRANTY
This 2GIG Technologies product is warranted against defects in material and workmanship
for 1 year. This warranty extends only to wholesale customers who buy direct from 2GIG
Technologies or through 2GIG Technologies' normal distribution channels. 2GIG
Technologies does not warrant this product to consumers. Consumers should inquire from
their selling dealer as to the nature of the dealer's warranty, if any.
There are no obligations or liabilities on the part of 2GIG Technologies for consequential
damages arising out of or in connection with use or performance of this product or other
indirect damages with respect to loss of property, revenue, or profit, or cost of removal,
installation, or reinstallation. All implied warranties for functionality, are valid only until the
warranty expires. This 2GIG Technologies Warranty is in lieu of all other warranties expressed
or implied.
For technical support in the USA and Canada
855-2GIG-TECH (855-244-4832)
For technical support outside of the USA and Canada
Contact your regional distributor
Visit 2gig.com for a list of distributors in your region
PN: 77‐000012‐001 Rev. D
2GIG Copyright © 2013. All rights reserved.