Activinsights GENEActiv Руководство по эксплуатации - Страница 11

Просмотреть онлайн или скачать pdf Руководство по эксплуатации для Измерительные приборы Activinsights GENEActiv. Activinsights GENEActiv 20 страниц.

Selecting the 'Allow Stop & Restart' option allows the button to remain active and control recording

stopping and starting. This is only recommended for laboratory testing.

'Immediately on Disconnect' starts recording as soon as the device is removed from the cradle.

The LEDs are inactive in this mode and the button will not interrupt recording, but instead will be

used as an event marker only, when required.

'At Future Time' allows the operator to choose a start time up to 2 weeks in the future. Recording

will start automatically at this point. The LEDs are inactive in this mode and the button will not

interrupt recording, but instead will be used as an event marker only, if required.

iv). Subject info

Once the date of birth is selected, the age will be calculated automatically. Enter the height in cm

and weight in kg. The height in feet/inches, weight in stones/pounds and BMI will then be calculated

automatically.

We do not recommend entering personal data, such as date of birth, as this can be entered post

data collection if required. It does not directly affect any data collected and means there is no

Personally Identifying Information stored on the device.

v). Configuration

Select which device(s) are to be configured. A tick box will appear next to the relevant device serial

number. At least one device must be selected. It can be useful to configure multiple devices together

when a trial subject will wear several GENEActiv devices on different body locations.

When 'Erase & Configure' is clicked, a pop-up message will automatically appear to warn that

continuing will erase all previously stored data and to confirm the recording start mode. There will also

be warning pop-ups if any mandatory information is missing, or if the battery charge is below 80%. If

the warning message appears due to the battery being less than 80% do not deploy the device.

Device configuration will take about 10 seconds and a pop-up message will automatically appear to

confirm that it has been set up successfully and is ready for deployment. The device will record for the

given data collection period. There is no need for any additional charging (this should be avoided due to

the important note below).

IMPORTANT: Once the configuration of the device is complete, it is important that the device

is not returned to the charger cradle at any point, until after data collection. If the device is re-

entered into the cradle for any reason, it will stop data recording and must be reconfigured to start

the data collection process.