DYNAMICS GROUP Dings 60 Series Руководство по эксплуатации - Страница 3
Просмотреть онлайн или скачать pdf Руководство по эксплуатации для Промышленное оборудование DYNAMICS GROUP Dings 60 Series. DYNAMICS GROUP Dings 60 Series 12 страниц. Hazardous brake
Также для DYNAMICS GROUP Dings 60 Series: Руководство по эксплуатации (12 страниц)
Печатать страницуINSTALLATION
CAUTION: To preserve pre-alignment of rotating discs
for ease of installation, do not operate manual release or
energize brake coil before installation.
NOTE: The brakes are designed for horizontal mounting.
Modification is required for vertical mounting. Brakes that
are modified will have a prefix on the model number of VO
(Vertical Over) or VU (Vertical Under).
Mounting Hub on Motor Shaft
For Model 6-60000-545:
Refer to Figure 3.
1.
Place rotating disc hub, with key, onto motor shaft with
part number facing away from motor. Measure from
motor face as shown.
2.
Tighten both setscrews to 8 - 10 lb. ft. torque.
For Model 6-60000-535:
Refer to Figure 4.
1.
Remove rubber v-ring from v-ring hub assembly.
2.
Place v-ring hub assembly onto motor shaft, with part
number facing away from motor. Measure from motor
face as shown.
NOTE: If motor shaft keyway extends into v-ring
area, install a key long enough to engage v-ring hub
assembly and rotating disc hub. See step (3) before
tightening setscrews. Tighten both setscrews to 35
lb. in. torque.
3.
Place "RTV" sealant in small amounts to fill crevices
only. Attention should be paid to the areas around and
between the v-ring hub assembly, reference the .040" x
o
45
chamfer, motor shaft, hub keyway and motor shaft
keyway. Use Dow Corning #739 RTV only; other types
may form acetic acid during curing if subjected to water
or high humidity. This will cause premature failure of
zinc plated parts.
CAUTION: If this procedure is bypassed, liquid
media may seep into the brake.
4. Replace v-ring onto v-ring hub assembly. Apply a small
amount of grease to the lip of the v-ring.
5. Place rotating disc hub with key onto motor shaft with
part number facing away from motor. Measure from
brake mounting face as shown. Tighten both setscrews
to 8 - 10 lb. ft. torque.
+ 1/32
5/16"
Hub
Motor
Figure 3
+ 1/32
27/32"
+ 1/32
1/4"
Hub
Motor
V-ring Hub
Assembly
Figure 4
3