Hifionics BRUTUS BRX160.2 Руководство по установке - Страница 8

Просмотреть онлайн или скачать pdf Руководство по установке для Усилитель Hifionics BRUTUS BRX160.2. Hifionics BRUTUS BRX160.2 13 страниц. Brutus brx series amplifers

Печатать страницу

BRX1100.1D / BRX1600.1D MONO AMPLIFIER APPLICATIONS

Basic application

Interconnect cable checklist:

- Connect the line inputs to a Radio/CD RCA outputs or line output of the

full range primary amplifier with good quality RCA cables. A "Y" adapter

may be needed as shown in the diagram.

- Use at least 16 gauge speaker wiring. These amplifiers have dual

speaker terminals, simplifying the hookup of multiple speakers. The 2

positives are the same and the 2 negatives are the same.

Crossover frequency control checklist:

- LOW PASS: 35Hz to 250Hz

- SUBSONIC:15 Hz to 35 Hz

- BASS EQ: 0 to 10dB

- PHASE: 0 to 180 degrees

Level control checklist:

- Refer to the section "Setting up systems after installation for best

performance"

DESIGNATED

MONO LINE INPUT

B O O S T

H F R - 3

M I N

M A X X

Dual Subwoofer Application

DESIGNATED

MONO LINE INPUT

B O O S T

H F R -3 M INM A X X

BRUTUS

Minimum final loudspeaker impedance:

- 1 ohm.

FULL RANGE

STEREO LINE INPUT

NOT USED

Note: You can use the Radio/CD designated mono line output

or a full range stereo line output. For full range stereo line output,

you will need an optional "Y-Adaptor" as shown

Y-ADAPTOR

MONO

SUBWOOFER

1-OHM MINIMUM

TO BATTERY +12v

VIA FUSE

REMOTE TURN-ON

CHASSIS GROUND

PARALLEL MONO

SUBWOOFERS

2-OHMS SVC EACH MINIMUM,

or 4-OHMS DVC EACH MINIMUM