Hifonics BRX616.4 Краткое руководство по установке - Страница 2
Просмотреть онлайн или скачать pdf Краткое руководство по установке для Усилитель Hifonics BRX616.4. Hifonics BRX616.4 2 страницы.
Печатать страницу
Setup
A
The input MODE switch will "sum" or
combine the right and left channel signals
in the MONO position to improve bass
Input Mode
performance. Select MONO only when the
amp is being used for subwoofers.
B
The XOVER Mode switch sets the type
of crossover that will be active. 4 channel
models will have two switches, one for each
Xover Mode
set of channels.
C
The HPF(high pass fi lter) control will limit the
output below the selected frequency. This
is typically used to protect midrange and hi
High pass
frequency speakers from damage and to
Adjustment
allow a smooth transition from a subwoofer.
D
The LPF(low pass fi lter) control will limit
output above the selected frequency. This
is used to allow a smooth transition to the
Low pass
higher frequency speakers.
Adjustment
E
The Bass EQ control will increase the power
output at 45Hz for more pronounced bass.
Exercise caution when using this control.
Bass Boost
Increase the level in small amounts until
distortion is noticed, then back off a little.
F
Some models include a bass
remote. Avoid adjusting the bass
remote while operating vehicle.
Remote Level
Control
G
This is a critical step to insure your amplifi er
is properly adjusted to match the signal
output level of your source unit.
Level Setting
THIS IS NOT A VOLUME CONTROL!
1.
If possible, with the source unit off, confi rm that the primary volume control is
turned down (counter clockwise).
2.
Turn on the source unit (CD, or MP3 player). Re-confi rm that the volume is
turned down. Make sure the source unit controls; balance, fader, bass and
treble are all set to center or "0" adjustment. Make sure that the green LED on
the end of the amplifi er is illuminated.
3.
Play a clean musical selection of which you are very familiar. CD is preferred.
Do not use radio signals for level setting. Hit play and start turning the volume
of the source unit up.
4.
Stop increasing the source unit volume when you reach 3/4 (about 75%) or until
you hear speakers begin to slightly start producing distortion.
5.
Increase the amplifi er level (clockwise) until distortion is heard, then back
the level down (counter clockwise) until the distortion is eliminated. Small
adjustments may need to be made to balance the levels of multiple amplifi ers.
Common System Setup
2ch - Full Range
4ch - Full Range
4ch - Mixed Mono
Mono
The information contained within this document is intended to offer some basic guidelines
for a few of the most common installations. More complex audio systems should be
installed by a competent professional. Additional installation information available at
www.maxxsonics.com
WARRANTY
Maxxsonics USA Inc. warrants this product, to the original consumer purchaser, to be free from
defects in material and workmanship for a period of two (2) years from the date of purchase.
Maxxsonics USA Inc. will, at it's discretion, repair or replace defective products during the warranty
period. Components that prove to be defective in materials and workmanship under proper installation
and use must be returned to the original authorized Maxxsonics USA Inc. retailer from where it was
purchased. A photocopy of the original receipt must accompany the product being returned. The
costs associated with removal, re-installation and freight are not the responsibility of Maxxsonics
USA Inc. This warranty is limited to defective parts and specifi cally excludes any incidental or
consequential damages connected therewith. To view the full warranty, please visit the website.
Hifonics products are designed and engineered in the USA by
847-540-7700
www.maxxsonics.com
Installation Guide
BRX316.4
BRX616.4
BRX1616.4
BRX5016.5
Congratulations on your choice of a Hifonics amplifi er.
This "Quick Start Installation" guide is meant to help you
"hook up" and play music. For more detailed information,
on system setting, speaker and subwoofer confi guration
and full specifi cations by model visit the website,
http://hifonics.com/manuals.html
HF BRX2015 QSG 01 - rev1
Quick Start
BRX1116.1D
BRX1516.1D
BRX2016.1D
BRX2416.1D
BRX3016.1D