Hifonics CYCLOPS 3K Руководство по эксплуатации - Страница 2
Просмотреть онлайн или скачать pdf Руководство по эксплуатации для Усилитель Hifonics CYCLOPS 3K. Hifonics CYCLOPS 3K 13 страниц. Mt olympus
Печатать страницу
HIfONICS Mt. OLYMPuS
2
HIgH PerfOrMaNCe aMPLIfIerS
The MT OLYMPUS Series products have been designed to a very high level of performance, with features
unavailable in any other product. All of the amplifiers have variable crossovers built in, with added touches
such as subsonic filter, parametric bass equalization and a remote control module that allows the overall
Level of bass boost to be controlled from the driver's seat.
To ensure years of listening pleasure, all amplifiers have a built in diagnostic mode that will detect shorted
speaker leads, low impedance, dangerous high temperatures, DC shorts and will shut down the amplifier to
help prevent damage. This series also features pre clip, soft clip and hard clip indication on the remote and
end panel of each amp to prevent damage to your audio investments.
tabLe Of CONteNtS
Check out our videos of new products, events and technical tutorials at
WWW.YOutube.COM/MaxxSONICSuSaINC
The contents of this manual may not be reproduced or copied without the written consent of
MAXXSONICS USA, Inc.
a. geNeraL INStaLLatION PrOCeDure
KeYS tO SuCCeSS
Follow these keys to success for your amplifier installation for reduced system noise and great
sound quality.
»
Separate Power/ground & rCa - Make sure that Power/Ground and RCA signal cables are at least
18" apart. Consider running Power/Ground on one side of the vehicle and RCA signal on the other.
»
Quality Cables - Use the highest quality RCA, Power and Ground Cables. Choosing great amplifiers
is only part of the installation. Use quality, connectors throughout the system to assure great sound and
reduced injected noise from the vehicles electrical system.
Chassis ground - Never use factory screws or bolts to electrically ground amplifiers. Use a short
»
(less than 18") 0-gauge wire for Cyclops 3K or a 4-gauge wire for Odin 2K with a ring terminal or
grounding distribution block. Remove paint and secure amplifier grounds directly to the chassis of the
3
vehicle.
6
Proper Power & fuse - Assure that you have fused each amplifier with the appropriate fuse within 12"
»
8
of the vehicles battery.
12
SYSteM DeSIgN
14
The success of any car stereo system relies on several factors, such as the system design, execution of the
17
installation, and system setup. Remember that any system is only as good as its weakest link.
20
It is important to know that higher power systems or amplifiers are not only useful for high sound pressure
21
levels (SPL) but also to establish headroom capability for an audio system. Headroom means that a system
to be able to reproduce musical peaks cleanly without distortion. Lower power amplifiers will clip earlier
than their more powerful cousins, and cause loudspeaker failure when overdriven due to the harmonics
generated by a clipped signal, thus overheating voice coils.
Amplifiers should be mounted with the fins running horizontally for best convection cooling, to minimize
overheating. Choose the best quality RCA cables for reliability and less engine noise interference in through
the audio system.
3