909 PS26W Руководство по эксплуатации - Страница 10

Просмотреть онлайн или скачать pdf Руководство по эксплуатации для Пила 909 PS26W. 909 PS26W 20 страниц. 26cc pole trimming saw

Печатать страницу

Connecting the J handle to the upper shaft

1. Lay the pole saw upper

shaft down so that the petrol

tank is resting on a secure

surface, or on the ground.

2. Insert both of the mounting

screws (+ one flat washer)

through the mounting

bracket, with one of the

screws going through the

screw hole in the J handle.

3. Once the screws are in

position, place the mounting

bracket with the J handle in

position onto the upper shaft.

4. Place the second mounting

bracket on the opposite

side so that both screws go

through the mounting bracket

securing the J handle into

position.

5. Secure the mounting brackets by adding the nut and

2 washers on each side of the bracket loosely.

Note:

It is suggested to loosely secure the nut and washers

first so that the handle can be placed into the most

appropriate and comfortable position for use.

6. The J handle generally sits best so that the top bar of the

handle is on the same side of the pole as the Key Start

switch.

IMPoRTANT:

Secure and

tighten the nuts.

Connecting the lower

shaft to the upper shaft

1. Loosen the shaft locking

knob. Then pull out the

shaft lock pin (11) and insert

the lower shaft (10) into

the upper shaft (9). Rotate the lower shaft until the pin

locates positively into the hole in the upper shaft.

Note.

When rotating the shaft the middle drive shaft needs

to engage so it may require up to a full turn to engage both

the middle drive shaft and to

locate the shaft lock pin.

2. Tighten the shaft locking

knob (18), using the 4mm

hex key (supplied) to secure

both shafts in place.

3. Using the 4mm hex key

check the connector clamp

screw is tight.

Adjusting the

shoulder strap

The shoulder strap (8) can be

attached to the pole saw by

clipping the carabiner on the

shoulder strap to the shoulder

strap attachment (31) located

above the key start switch.

Adjust the shoulder strap accordingly so that it is comfortable

to use and supports some weight of the pole saw.

Adding chain oil

WARNING.

Never start work

unless the chain and bar are

lubricated.

Note:

Always make sure the

engine is turned off before filling

the oil.

1. Place the pole saw so that

the oil cap is facing up.

Untwist and remove the oil tank cap.

2. Fill the tank to approx 80% capacity with a premium

blend of Bar and Chain Lubricant.

3. Replace the cap and wipe up any oil spillage.