Hifonics HFi2500D Руководство пользователя - Страница 5
Просмотреть онлайн или скачать pdf Руководство пользователя для Автомобильный усилитель Hifonics HFi2500D. Hifonics HFi2500D 15 страниц. Hifonics hfi100.4: user guide
Печатать страницу
- 1. Table of Contents
- 2. General Installation Procedure
- 3. Amplifier Feature Descriptions
- 4. Hfi100.2 2-CHANNEL AMPLIFIER APPLICATIONS
- 5. Full Range Stereo / Mono
- 6. Hfi55.4 / Hfi100.4 4-CHANNEL AMPLIFIER APPLICATIONS
- 7. Hfi1000D / Hfi1500D / Hfi2000D / Hfi2500D CLASS 1 CHANNEL AMPLIFIER APPLICATIONS
- 8. Features and Specifications
- 9. Setting up Systems after Installation for Best Performance
- 10. Troubleshooting a System
- 11. Troubleshooting and Diagnostics
- 12. Product Warranty
HFi100.2 2 CHANNEL AMPLIFIER APPLICATIONS
FULL RANGE STEREO
This is the most basic application for the HFi Series 2 channel amplifiers.
1. Interconnect cable checklist:
Connect the LINE INPUTS to the Radio/CD with good quality RCA cables.
2. Crossover Switch:
The X-OVER switch must be in the FULLposition.
3. Crossover frequency control checklist:
N/A for full range operation.
FULL RANGE
STEREO LINE INPUT
MONO
This application illustrates the basic mono bridging method for all Hifonics
amplifiers.
Interconnect cable checklist:
A MONO signal source is required, such as would be available from the mono
sub bass output of an active crossover, whether stand alone, or built into a head
unit or equalizer. Important: Do not be tempted to connect the hot, or positive
outputs, from any source together to obtain a mono signal, as this could very
well damage the output stage of that source.
It is necessary to feed the SAME signal to both left and right inputs via a Y-
adapter RCA cable. Connect the mono speaker positive terminal to the LEFT +,
and its negative terminal to RIGHT -.
FULL RANGE
MONO LINE INPUT
VIA Y-ADAPTER
FROM MONO SOURCE
4. MODE:
Should be in the STEREO position.
5. Line Level:
Refer to the section "Setting up systems after installation for best performance"
NOTE: Minimum final loudspeaker impedances:
4 & 2 Ohms stereo mode or 4-Ohms mono mode
This amplifier will not do 1 Ohm stereo or 2/1 Ohm mono operation.
H F
Switch setting checklist:
- The AMPLIFIER X-OVER switch should be in the LPF position and the MODE
should be in the MONO position.
Crossover frequency control setting checklist:
LPF: 11 o'clock
Minimum final loudspeaker impedance:
- 4 ohm mono.
H F
FULL RANGE
SPEAKERS
TO BATTERY +12v
VIA FUSE
REMOTE TURN-ON
CHASSIS GROUND
FULL RANGE
MONO SPEAKER
TO BATTERY +12v
VIA FUSE
REMOTE TURN-ON
CHASSIS GROUND
3