Hifonics Titan Series TXi 1700 Руководство пользователя - Страница 16
Просмотреть онлайн или скачать pdf Руководство пользователя для Автомобильный усилитель Hifonics Titan Series TXi 1700. Hifonics Titan Series TXi 1700 20 страниц.
Печатать страницу
Speaker & RCA Connections
MASTER/SLAVE-MODE / Subwoofer-Mode with two Ampifiers
• Connect the "LINE IN" (L & R) of the MASTER-amplifier to the head unit´s line output with appropriate good quality RCA cables.
• Connect the "SLAVE OUT" RCA Output of the MASTER-Amp with the "LINE IN" RCA Input of the SLAVE-AMP.
• Connect the "REMOTE"-Terminal of the MASTER-Amp with the supplied BASS REMOTE.
• Connect the "REMOTE"-Wire of your head unit with the REM-Terminals of both Amplifiers.
• Connect the subwoofer with appropriate wires to the terminal block (SPEAKER OUTPUT - and +) of both amplifiers. As optional feature an
additonal Subwoofer can be connected to the non-occupied terminals.
• Connect the Protect/Bridge Connection of the Master with the Protect/Bridge Connection of the Slave.
This connection warrants if there is an operation fault both amps, Master and Slave, would go into protection mode so the amps are prevented
for any possible damages.
• The minimum final subwoofer impedance must not be lower than 2 Ohms in total (1 Ohm for each Amplifier) or 2 Ohms bridged. Too low speaker
loads result in too high heat dissipation and may cause the amplifier run into protection.
• Please observe correct speaker channels and polarity as printed by the speaker terminal.
MASTER
SLAVE
Subwoofer
1 - 8 Ohm
Subwoofer with Dual-Voice-Coil
MASTER
SLAVE
SPEAKER OUTPUT
SPEAKER OUTPUT
Subw ofer w th D al-Voic
o
i
u
e-C l
Caution: Please observe t e r ght polarity. Slave´s - to Loudspeaker´s + and Slave´s + to Loudspeaker´s -
SET-UP MASTER-Amp
MODE - Schalter
• Switch to the "LP or FULL"-position.
PHASE
FREQ RANGE
Q-Control
SUB BOOST
BASS REMOTE
SUB SONIC
LOW PASS
LEVEL
• Attend regarding notes on page 14 if you use
LOW PASS-MODE or on page 15 if you
use FULL-MODE.
TXi 1700
Do not connect speaker (-) to the ground or vehicle's chassis.
Bass Remote Control - connection for remote control.
This contoller regulates the bass level from e.g. the driver's seat.
Connect Master´s Protect/Bridge
with Slave´s Protect/Bridge
+
-
oi 1 - 8 Oh s per Voi e-Co l
m
c
i
h
i
Caution!
2 Subwoofers with Single-Voice-Coil
MASTER
SPEAKER OUTPUT
Subwoofer with Single-Voice-Coil 1 - 8 Ohms
SET-UP SLAVE-Amp
MODE - Switch
• Switch to the "SLAVE"-position.
PHASE
FREQ RANGE
Q-Control
SUB BOOST
BASS REMOTE
SUB SONIC
LOW PASS
LEVEL
• All controllers are in this operation mode without function.
Only the output signal of the Master-Amp will be amplified.
0dB
18dB
SLAVE
SPEAKER OUTPUT
.
+
-