909 HD1050 Руководство по эксплуатации - Страница 5
Просмотреть онлайн или скачать pdf Руководство по эксплуатации для Сверло 909 HD1050. 909 HD1050 13 страниц. 909 hd1050; hd850 high performance hammer action drill
Печатать страницу4) Power tool use and care
a) Do not force the power tool. Use the correct power
tool for your application.
do the job better and safer at the rate for which it was
designed.
b) Do not use the power tool if the switch does not turn
it on and off.
Any power tool that cannot be controlled
with the switch is dangerous and must be repaired.
c) Disconnect the plug from the power source and/or
the battery pack from the power tool before making
any adjustments, changing accessories, or storing
power tools.
Such preventive safety measures reduce
the risk of starting the power tool accidentally.
d) Store idle power tools out of the reach of children
and do not allow persons unfamiliar with the power
tool or these instructions to operate the power tool.
Power tools are dangerous in the hands of untrained users.
e) Maintain power tools. Check for misalignment or
binding of moving parts, breakage of parts and any
other condition that may affect the power tool's
operation. If damaged, have the power tool repaired
before use.
Many accidents are caused by poorly
maintained power tools.
f ) Keep cutting tools sharp and clean.
maintained cutting tools with sharp cutting edges are
less likely to bind and are easier to control.
g) Use the power tool, accessories and tool bits etc.
in accordance with these instructions, taking into
account the working conditions and the work to be
performed.
Use of the power tool for operations different
from those intended could result in a hazardous situation.
h) This appliance is not intended for use by persons
(including children) with reduced physical, sensory
or mental capabilities, or lack of experience and
knowledge,
unless they have been given supervision or
instruction concerning use of the appliance by a person
responsible for their safety.
The correct power tool will
Properly
i) Children should be supervised to ensure that they do
not play with the appliance.
5) Service
a) Have your power tool serviced by a qualified repair
person using only identical replacement parts.
will ensure that the safety of the power tool is maintained.
Additional safety rules for drills
•
Wear ear protectors with impact drills. Exposure to noise
can cause hearing loss.
•
Use auxiliary handles supplied with the tool. Loss of
control can cause personal injury.
•
If possible, always use clamps or a vice to hold
your work.
•
Always switch off before you put the drill down.
•
Ensure that the lighting is adequate.
•
Do not put pressure on the drill, such that it slows the
motor down. Allow the drill bit to cut without pressure. You
will get better results and you will be taking better care of
your tool.
•
Keep the area free of tripping hazards.
•
Do not let anyone under 18 years operate this tool.
•
Only use accessory bits in good condition.
•
Before drilling, check that there is sufficient
clearance for the drill bit under the workpiece.
•
Do not touch the bit after operation.
It will be very hot.
•
Keep your hands away from under the workpiece.
•
Never use your hands to remove sawdust, chips or waste
close by the bit.
•
Rags, cloths, cord, string and the like should never
be left around the work area.
•
Support the work properly.
•
If you are interrupted when operating the drill, complete
the process and switch off before looking up.
5
This