Autonics FX6Y-I4 Руководство по эксплуатации - Страница 6
Просмотреть онлайн или скачать pdf Руководство по эксплуатации для Измерительные приборы Autonics FX6Y-I4. Autonics FX6Y-I4 6 страниц. Din w72xh36mm of counter/timer with indication only
Печатать страницу
FXY Series
Dot for Decimal Point / Hour. Min. Second
RUN mode
3 sec
RESET
Setting mode
Counter mode
Set decimal point
----
by front
RESET
Proper Usage
● Follow instructions in 'Proper Usage'. Otherwise, It may cause unexpected accidents.
● 24-48VDC, 24VAC power supply should be insulated and limited voltage/current or Class 2, SELV power supply device.
●
Use the product, 0.1 sec after supplying power.
● When supplying or turning off the power, use a switch or etc. to avoid chattering.
● Install a power switch or circuit breaker in the easily accessible place for supplying or disconnecting the power.
●
In case of contact input, set count speed to low speed mode (1cps or 30cps) to operate.
If set to high speed mode (2kcps or 5kcps), counting error occurs due to chattering.
●
Keep away from high voltage lines or power lines to prevent inductive noise.
In case installing power line and input signal line closely, use line filter or varistor at power line and shielded wire at input
signal line.
Do not use near the equipment which generates strong magnetic force or high frequency noise.
●
This product may be used in the following environments.
①Indoors (in the environment condition rated in 'Specifications')
②Altitude max. 2,000m
③Pollution degree 2
④Installation category II
M-72
3 sec
RESET
DP
RESET
Timer mode
CLR
Hour, Min, Sec are not divided
with dot.
E.g.) 5959: 59 min 59 sec
※ In run mode, hold the
enters setting mode [DP].
※ In setting mode, hold the
saves the setting and returns to RUN mode.
※ If there is no
setting mode, it returns to RUN mode.
RESET
SET
Hour, Min, Sec are divided with dot.
E.g.) )5(59: 59 min 59 sec
key for over 3 sec, and it
RESET
key for over 3 sec, and it
RESET
key input for 60 sec when entering
RESET