Galaxy 3500Msi Руководство по установке и эксплуатации - Страница 8
Просмотреть онлайн или скачать pdf Руководство по установке и эксплуатации для Сантехническая продукция Galaxy 3500Msi. Galaxy 3500Msi 17 страниц.
Печатать страницу
7. Set the power select knob to 'Cold'
(9 o'clock position) and turn temperature
knob fully anti-clockwise to allow the unit to
fill with water prior to any heat settings
being selected.
8. Place seal washer into the shower hose nut
then tighten to the shower outlet pipe.
Operate the shower first without the handset
to flush out particles.
Fit the seal washer into the other shower
hose nut and then fit the handset.
Operate the shower as in section 4, then
please check:
That the water gets to a satisfactory
temperature and water flow can be
adjusted by the temperature knob.
That the power select knob operates in all
3 positions.
Check again for leaks.
That the holes in the shower handset are
not blocked.
9. DEMONSTRATE OPERATION TO
USERS, AND LEAVE THIS BOOK WITH
THEM FOR FUTURE REFERENCE.
Ensure the electricity and water are turned on to
Turn electricity supply on at isolation switch
the unit.
Your shower has 2 control knobs and a
push-button (fig.12).
Knob 'A' controls the power selection.
'High'
- Full power
'Eco'
- Half power
'Cold'
- No heat
Knob 'B' controls the temperature of the water.
Button 'C' starts and stops the shower.
TO START THE SHOWER
Press Button 'C' - Water will start to flow.
Set your desired power setting - normally 'High'
(fig.10a/10b).
10a
It is recommended that you do not wholly enter
the water spray during this period, especially if
the shower has just been used.
If the water is not at your desired showering
temperature, turn Knob 'B' a small amount
until the desired temperature is achieved.
Turn anti-clockwise for cooler (fig.11a).
Turn clockwise for warmer (fig.11b).
11a
Allow about 20 seconds for the temperature
of the water to stabilise.
Final adjustment may be anywhere on the scale.
If after turning fully anti-clockwise, water is still
too hot, adjust Knob 'A' to 'Eco' setting and re-
adjust as previously detailed.
Water flow will be reduced on this setting.
12
8
10b
11b