Galaxy Aqua 9000 XP Руководство по установке - Страница 3

Просмотреть онлайн или скачать pdf Руководство по установке для Сантехническая продукция Galaxy Aqua 9000 XP. Galaxy Aqua 9000 XP 11 страниц. Pumped instantaneous electric shower

Печатать страницу

1. Plumbing Connections

SECTION

FILTER MAINTENANCE

INSTRUCTIONS for INSTALLERS

and SERVICE ENGINEERS

It is recommended that the filter is

periodically cleaned in order to maintain

the performance of the shower. It is

essential that this operation is carried out

by a competent person.

SWITCH OFF THE ELECTRICITY

SUPPLY . There is no need to turn off the

mains water supply when cleaning the

filter.

Remove the cover and disconnect the

plug.Turn off the water supply to the unit

by rotating the lever on top of the filter

service shut off valve (Fig.21) anti-

clockwise a quarter turn.

Fig.21

Filter Service

Shut-Off

Valve

Do not rely on the filter service shut off

valve when carrying out repairs or service

to other areas of the shower unit.

Unscrew the three screws in filter cover

(Fig.22) remove cover.Take out filter and

wash under running water. Ensure all

debris etc. is removed.

Replace filter. Replace cover ensuring all

three screws line up. Replace the three

screws. DO NOT OVERTIGHTEN.

Fig.12

Fig.22

Filter Cover

Screws

Turn unit water supply back on by rotating

the lever on top of the filter service shut

off valve clockwise a quarter turn.

Before replacing the cover, it is strongly

advised to prime the unit by opening the

bleed screw until water drains from it.

Close the bleed screw and connect the

plug to the cover. Replace the cover and

secure with the fixing screws.

Switch on the electric supply and start the

shower on the COLD SETTING ONLY

and with the temperature control rotated

fully anti-clockwise.

When a smooth flow of water is obtained,

the shower can then be used in the

Normal manner.

ATTENTION!

NOTE: IN NORMAL USE, IT IS IN

ORDER TO LEAVE THE WATER

SUPPLY PERMANENTLY ON TO THE

SHOWER UNIT, BUT AS WITH MOST

ELECTRICAL APPLIANCES, THE

UNIT MUST BE SWITCHED OFF

AT THE ISOLATING SWITCH

WHEN NOT IN USE.

PACK

SECTION

CONTENTS

PACKING CONTENTS

Shower Unit

Showerhead

Showerhead Key

Flexible Hose

Slider Rail Tube

Slider Rail Brackets

Slider Rail Showerhead Holder

Soap Dish

Hose Retaining Ring

Screw Pack

PACK

SECTION

CONTENTS

PLEASE READ THIS IMPORTANT

SAFETY INFORMATION

Products manufactured by Galaxy are

safe and without risk provided they are

installed, used and maintained in good

working order in accordance with our

instructions and recommendations.

DO NOT connect this shower directly

to the mains water supply.

DO NOT operate shower if frozen, or

suspected of being frozen. It must

thaw out before using.

DO NOT operate the unit if the spray-

head or spray hose becomes

damaged.

DO NOT restrict flow out of the

shower by placing sprayhead in direct

contact with your body.

DO NOT operate the shower if water

ceases to flow during use or if water

has entered inside the unit because

of an incorrectly fitted cover.

WARNING: If re-starting the shower

immediately after stopping, be aware

that a slug of hot water will be

expelled for the first few seconds.

GENERAL

1. Isolate the electrical and water supplies before

removing the cover.

2. Read all of these instructions and retain them for

later use.

3. DO NOT take risks with plumbing or electrical

equipment.

4. Isolate electrical and water supplies BEFORE

proceeding with the installation.

5. The unit must be mounted onto the finished wall

surface (on top of the tiles). DO NOT tile up to unit

after fixing to wall.

6. Contact Customer Service (see back page),

if any of the following occur;

a) If it is intended to operate the shower at pressures

above the maximum or below the minimum stated.

b) If the unit shows a distinct change in performance.

c) If the shower is frozen.

7. If it is intended to operate the shower in areas of

hard water (above 200 ppm temporary Hardness), a

scale inhibitor may have to be fitted.

The sprayplate and cartridge must be cleaned

regularly with descalent to remove scale and debris,

otherwise restrictions to the flow on the outlet of the

unit will result in higher temperatures and could also

cause the Pressure Relief Device in unit to operate.

9. This product is not suitable for mounting into

steam rooms or steam cubicles.

PLUMBING

1. The plumbing installation must comply with Water

Regulations, Building Regulations or any particular

regulations as specified by Local Water Company or

Water Undertakers and should be in accordance with

BS 6700.

2. The supply pipe must be flushed to clear debris

before connecting to shower unit.

3. DO NOT solder pipes or fittings within 300mm of

shower, as heat transfer can damage components.

4. DO NOT fit any form of outlet flow control as

the outlet acts as a vent for the heater can.

5. DO NOT use excessive force when making

connections to the flexible hose or sprayhead, finger

tightness is sufficient.

6. Al plumbing connections MUST be completed

BEFORE making the electrical connections.

ELECTRICAL

1. The installation must comply with BS 7671

Requirements for electrical installations' (IEE wiring

regulations) or any particular regulations as specified

by the local Electrical Supply Company.

2. This appliance MUST be earthed.

3. In accordance with 'The Plugs and Sockets etc.

(Safety) Regulations 1994', this appliance is

intended to be permanently connected to the fixed

wiring of the electrical mains system.

4. Ensure all electrical connections are tight to

prevent overheating.

5. Fuses do not give personal protection against

electric shock.