DYNAPAR HS35IQ Series Руководство по установке - Страница 3
Просмотреть онлайн или скачать pdf Руководство по установке для Медиаконвертер DYNAPAR HS35IQ Series. DYNAPAR HS35IQ Series 7 страниц. Heavy duty hollowshaft encoder
Печатать страницуSTEP 5:
Install Washers on Tether
Slide the flat nylon washer on the side away from the bend and the
flanged nylon washer on the side of the bend and press them together
until they are fully seated in the tether hole. One steel washer is to be
used on each side of the nylon washer.
STEP 6:
Slide Encoder on Shaft
Carefully slide the encoder all the way down until the tether rests on
the motor face without any stress on the tether. Do not tighten the shaft
clamp on the encoder yet
STEP 7A:
Secure Tether to Mounting Face (Motor Mount)
Rotate the tether arm until it is at the correct orientation and is aligned
with the mounting holes on the the motor or equipment. Install one
steel washer on both sides of the nylon washer. Refer figure above.
Fasten the tether arm to the motor or machine housing using the
supplied 3/8" bolt (4.5" C-face applications) or 1/2" bolt (8.5" C-face
applications). Ensure that there is no stress or flexing of the tether arm
when secured.
Application Assistance 1.800.873.8731 (847.662.2666) Option 3
STEP 7B:
Secure Tether to Mounting Face
(Fan Cover Mount)
T-BOLT
Slide and insert the T-bolt as shown in the figure into the fan cover.
Use the supplied insulating hardware and washers as shown. Tighten
the jamnut to firmly secure the tether.
STEP 8:
Tighten Encoder Clamp onto Mating Shaft
Check to make sure that the tether is still in its "unstressed" condition.
Adjust position of encoder on shaft if necessary and then tighten the
shaft clamp on the encoder. Tighten clamp to stated torque value
provided on encoder datasheet (50-55 in-lbs.).
NOTE:
Encoder models with split clamps have two screws to tighten
down. Please ensure that both screws on the clamp are tightened
down securely. You may have to rotate the shaft to tighten both
screws down.
STEP 9:
Good Installation Check Point
.67
[
16.9
]
Follow the 3 step installation check to ensure a good installation thus
far. Refer to figure above for key reference dimensions
A. Check clearances from mounting face. Ensure you have a minimum
clearance of 1/16" between the encoder shaft and any non-rotating
surface closest to the encoder shaft
B. Check tether installation. Make sure that the tether is unstressed.
There should be no visible bending or deflection on any surface of the
tether. Visible tether deflections should be corrected immediately. If
the tether is bent or distorted, DO NOT USE, and call the factory for a
replacement tether. Tether installation is critical to the long life of the
bearings and improper tether installation will lead to excessive bearing
loads and encoder failure.
STEEL WASHERS
INSERTED T-BOLT POSITION
JAM NUT
TETHER ARM
NYLON WASHERS
FAN COVER (MOTOR)
T-BOLT AFTER 1/4 TURN
MAXIMUM
2.60
SHAFT PROTRUSION
[ ]
66
FROM MOUNTING FACE
FOR USE OF END CAP
RECOMMENDED 1.60" OR LONGER
1.75
[
44,5
]
MATING SHAFT ENGAGEMENT;
MINIMUM 1.25" REQUIRED
CHECK WOBBLE
ON THIS FACE
.20
TYPICAL CLEARANCES
[
5.1
]
FROM MOUNTING FACE
Page 3