Galaxy Audio JACKS in the BOX JIB/BT5R Руководство пользователя - Страница 5

Просмотреть онлайн или скачать pdf Руководство пользователя для Приемник Galaxy Audio JACKS in the BOX JIB/BT5R. Galaxy Audio JACKS in the BOX JIB/BT5R 8 страниц. Portable wireless xlr bluetooth 5 recevier

Печатать страницу

Galaxy Audio JACKS in the BOX JIB/BT5R Руководство пользователя

Receiver Bluetooth Pairing and Unpairing

Wireless Pairing Setup

1. Power On Receiver:

Flip the POWER switch to "ON". The receiver will immediately be in pairing mode.

NOTE: The "PAIR" LED will quickly ﬂash blue and red while unpaired.

2. Ready Your Bluetooth Enabled Device:

Make sure your Bluetooth enabled device has its Bluetooth feature turned on and is within range.

3. Pair Your Bluetooth Enabled Device:

Find the receiver (JIB/BT5R) in your device's Bluetooth

NOTE: Once paired, the "PAIR" LED will slowly ﬂash blue.

4. Play Your Audio:

On your Bluetooth

device, start playing audio.

NOTE: While playing, the "PAIR" LED will remain a solid blue.

Stereo-Link Setup (Optional)

1. Pair Receivers:

To Stereo-Link, you must first pair the two receivers. Power on both JIB/BT5R receivers then press and hold both pair

buttons for 2 seconds, when paired both will ﬂash blue quickly for a few seconds.

2. Linking Receivers to Smart Device:

Once paired one of the two receivers will blink between Red and Blue, this indicates it is ready to pair with your

Bluetooth device. In your Bluetooth enabled device, scan for devices and locate the JIB/BT5R. Tap it to connect to

the receivers.

Disconnecting Stereo-Link, Bluetooth Connection, and Changing Paired Device

1. Disconnecting Stereo-Link:

To disconnect the Stereo Link, press and hold the "STEREO-LINK" button on either one receiver.

NOTE: The disconnected receiver will be the secondary that did not ﬁrst pair with the Bluetooth

The disconnected receiver's "Pair" LED will alternate ﬂashing between blue and red.

2. Unpair From Your Bluetooth Enabled Device:

To disconnect, press the "PAIR" button. The status LED will alternate between blue and red, signaling that the

receiver is unpaired and ready to pair to a new device.

NOTE: The receiver will remember the previously connected device for the next use. You can play audio from that same

device. To use a diﬀerent Bluetooth

Pair Your New Bluetooth Enabled Device:

Repeat the previous pairing steps with your new device.

NOTE:

The JIB/BT5R uses a Bluetooth

Once the JIB/BT5R is paired with a Bluetooth

always a chance of interference with any Bluetooth

as many cell phones and WiFi routers. These have higher outputs than Bluetooth

enabled device, you will need to disconnect from the previous device ﬁrst.

5.0 chip and has a range of up to 100 meters under optimal conditions.

settings to connect.

device, other Bluetooth

connection. Bluetooth

device.

devices cannot pair to it. There is

is in the same frequency band

and can cause interference.