DynaQuip WaterCop Classic Руководство пользователя и руководство по установке - Страница 14

Просмотреть онлайн или скачать pdf Руководство пользователя и руководство по установке для Измерительные приборы DynaQuip WaterCop Classic. DynaQuip WaterCop Classic 20 страниц.

Печатать страницу

Choose a dry location to install the WaterCop . ® The front control panel should be easily

visible in order to see what position the valve is in (open/closed) and accessible for

resetting after a leak has been detected and corrected, and for checking and resetting the

radio receiver code if necessary . Place the valve where the housing is protected from use

as a step or other excessive loads . The shut-off valve must be installed:

•

In the main water line;

•

Just downstream from the main water shut-off valve;

•

In a dry location (indoors only);

•

Where it is accessible for checking and resetting the valve and for resetting the

radio receiver code, if necessary; and

•

Where the case is protected from use as a step or other excessive loads .

CAUTION:

tightening fittings. Use a wrench on the valve flats that are provided.

CAUTION:

or motor housing. Proper precautions should be taken to prevent damage

from heat when installing the unit. Remove plastic housing before

soldering valve in place.

WARNING:

Mounting Actuator to Valve

1 . Make sure the valve and motor box are both in the OPEN position .

a . The slot in the valve stem should be in line with the valve body, end to end .

b . Apply power to the control box . The green light should be ON . If not press the

green button and the unit will cycle to the OPEN position . Disconnect power .

2 . Place the spring clip around neck of the valve as shown .

3 . Place O-ring into valve mounting recess .

4 . Slide the valve on to the mounting pins

in the position shown .

IMPORTANT: The control box must

be aligned with the valve as shown .

5 . Secure by compressing the spring

clip and sliding it to the inside of the

mounting pins .

6 . Release clip . Make sure the clip is

inserted into the groove in all four

mounting pins .

Never use the housing for leverage when mounting this unit or

High heat from soldering or brazing can damage valve seats

Do not use on fire sprinkler systems.

Spring Clip

O-Ring

Mounting Pins

Control Box

Valve