DynaQuip Controls WaterCop classic Руководство пользователя и руководство по установке - Страница 9

Просмотреть онлайн или скачать pdf Руководство пользователя и руководство по установке для Контроллер DynaQuip Controls WaterCop classic. DynaQuip Controls WaterCop classic 12 страниц.

Печатать страницу

Troubleshooting

•

If the flood sensor does not close the valve, check that the sensor has power and batteries and/or AC adaptor are

installed correctly .

•

If the batteries have power and the wireless sensor still does not make the valve close, physically remove it from its

installed location and place it next to the WaterCop

to the WaterCop

valve, but not when it is installed in a remote location, try moving the sensor to a different position or

try a different wireless sensor . Some possible causes of signal reduction are steel construction, foil-backed insulation

or other large metallic barriers . You may also use a range enhancing repeater (WPR - sold separately) to extend the

effective range of the wireless signals.

•

If the unit still does not function properly, check the digital code settings (see instructions for changing digital codes) .

•

If the code matches the code on the WaterCop

Installation of Flood Sensor

Once testing is complete, finish installation of the flood sensors by unwinding the cord and placing the sensor probe on

the floor at the lowest point (where water would naturally collect) in the area to be monitored . Be sure that the sensor is

placed FLAT on the floor so water can be detected as soon as it begins to accumulate. The sensor may be secured to the

floor with adhesive dots (included), taking care that the metal probes are

not covered . Verify that the transmitter and wire are clear of doors,

drawers, sharp edges, or other hazards that may cause damage .

Unplug the WaterCop

The WaterCop

can now be installed.

Prior to installation, read all warnings and precautions carefully .

Installation Procedure

Check the contents of the carton with the products listed on the

carton label . The shipping package should contain the following:

•

1 ea . WaterCop

with power adaptor (20' cord)

•

1 ea . Owner's Manual/Installation Guide

Note: The package may contain sensors if purchased as part of kit .

Read Operating Instructions before any installation is attempted . All

sections of this Owner's Manual/Installation Guide should be read

and completely understood .

Review Location and Type of Main Supply Line

The main supply line should enter the house in either the basement

or a crawl space beneath the first floor . The water main shut-off

valve is usually located near where the line comes through the

basement wall or just after the water line enters the living area from

the crawl space . In apartments, townhouses, and manufactured

housing constructions the water main shut-off valve can usually

be found in close proximity to the water heater installation . The

WaterCop

valve should be installed in the main water line just

downstream from the main shut-off valve in your home . The water

supply must be shut off prior to installation of the WaterCop

DynaQuip Controls • 10 Harris Industrial Park • St. Clair, MO 63077

Tel. 800-545-3636 • Fax. 636-629-5528 • www.watercop.com

valve, and it still does not function properly, replace the sensor .

after the testing is complete.

valve . Repeat test . If the sensor operates properly when it is closer

Water level

Sensor placed at a low spot

in the path of water flow where

it will make contact with sensor .

Probe

ncin g

Rang e Enha

Repe ater

TRAN SMIT

RECE IVE

St. Clair, MO

DynaQu ip

Controls , Inc.

www.w atercop

.com

Wat er Sen sor

& Tran smi tter

St. Clair, MO

Contro ls, Inc.

DynaQ uip

.com