909 HT8750-AUOXY Руководство по эксплуатации - Страница 9
Просмотреть онлайн или скачать pdf Руководство по эксплуатации для Инвертор 909 HT8750-AUOXY. 909 HT8750-AUOXY 16 страниц. 500 watt
Печатать страницуOperating environment
For best operating results, your converter should be placed
on a flat surface, such as the ground, car floor or seat, or
other solid surface to help diffuse the heat that is generated.
Position the converter as close to the DC power source as
possible.
The converter should only be operated in locations that
meet the following criteria:
DRY – Do not allow water and/or other liquids to come into
contact with the converter.
COOL – Ambient air temperature should be between 30°F
(–1°C) non-condensing and 105°F (40°C). Do not place
the converter on or near a heating vent or any piece of
equipment that is generating heat above room temperature.
Keep the converter out of direct sunlight.
VENTILATED – Allow at least three inches of clearance
from other objects to ensure free air circulation around the
converter. Never place items on or over the converter during
operation.
SAFE – Do not locate converters in an area, room or
compartment where explosives or flammable fumes might
be present, such as engine rooms, engine compartments,
and boats or small, unvented battery compartments.
Marine applications
DO NOT install the converter below or near the waterline,
and keep the converter away from moisture and water. The
unit's housing is moisture-resistant (NOT waterproof).
ONLY install the converter on a level, stable surface where
it is not likely to fall or be knocked over; and is not subject
to vibration.
Use ONLY non-corrosive marine fasteners and fittings for
installation.
WARNING: TO REDUCE THE RISK OF ELECTRIC
SHOCK OR PROPERTY DAMAGE
In all marine applications, always observe the directions
given above, as well as those listed in the Important Safety
Instructions of this manual.
Connecting to a power source using the 12
volt dc vehicle adapter plug with "o" ring
connectors
The DC Accessory Outlet Plug is suitable for operating the
converter at power outputs up to 100 watts.
1. Check to make sure the converter's On/Off switch has
been turned off (the power/fault LED is not lit).
2. Turn the red plastic cap (counterclockwise) on the
converter's positive (+) cable post and remove. Attach the
positive "O" ring at the end of the red 12 volt DC vehicle
adapter cable. Replace the cap and turn clockwise to
secure. Do not over-tighten.
3. Turn the black plastic cap on the converter's negative
(–) cable post counterclockwise and remove. Attach
the negative "O" ring at the end of the black 12 volt
DC vehicle adapter cable. Replace the cap and turn
clockwise to secure. Do not over-tighten.
4. Connect the 12 volt DC vehicle adapter plug to a
vehicle's accessory outlet or other 12 volt DC power
source. Make sure there is adequate space for proper
ventilation of the converter.
5. Rotate the plug slightly to make sure there is good
contact.
CAUTIONS
•
Connect directly to power source using the included
Battery Clips when operating above 100 watts.
•
Do not use with positive ground electrical systems.
•
Reverse polarity connection will result in a blown fuse
and may cause permanent damage to the converter.
Note: Most vehicle accessory outlet circuits have fuses
rated at 15 to 20 amps or greater. To operate at full wattage,
either use the supplied battery clips or directly wire to the
power source with wire and fuse (NOT SUPPLIED).
9