dynarex 10466 Краткое руководство по эксплуатации - Страница 2
Просмотреть онлайн или скачать pdf Краткое руководство по эксплуатации для Внутренняя отделка dynarex 10466. dynarex 10466 2 страницы. Homecare half-length bed rail cross bar mount
Печатать страницу
WARNINGS
Read instruction carefully before
installing. Before use, ensure that the
bed rail is assembled and installed as
described, that all attaching hardware
is securely tightened, and that the bed
rail is securely in place.
DO NOT use the bed rail as a handle
for getting into or out of bed; this could
result in personal injury and damage
to the bed rail.
INSTALLATION
1. Prepare the bed in a flat position.
The carton should include the
following:
2. Place crossbrace on the head end
of the frame between the first and
second spring.
3. Turn the barrel so that the lock
plate on the locking collar is
facing down.
DO NOT exert side pressure on the
bed rail; this could deform or break it.
DO NOT use the bed rail as a push
handle for moving the bed; this could
deform or break it.
DO NOT use the bed rail if a proper fit
in installation cannot be achieved.
Contact your dealer.
4. Insert the lock plate on the far side
of the bed so that it is under the
lip of the frame.
Hex Screw
(DO NOT REMOVE)
Barrel
Spring
Loaded
Tab
Knob
Lock Plate on
Locking Collar
Bed Frame
Lip of Bed
Frame
5. Push the crossbar together to
allow for the locking collar to
enter inside the frame.
6. Slowly release the crossbar so the
locking plate inserts into the lip of
the bed frame on the near side.
7. Rotate the barrel so that the tab
is facing down thereby locking
the crossbar into position.
Lock Plate on
Locking Collar
Tab
Spring Loaded
Knob
OPERATING INSTRUCTIONS
LOWERING/RAISING THE RAIL
1. Hold the rail, while pulling the
spring loaded knobs.
2. Lower or raise the rail to the
desired height.
8. Place the second crossbrace on
the bottom of the back rest panel
of the frame. Repeat steps 2-6 to
secure the crossbrace to the bed.
Barrel
9. Insert one bed rail into the barrels
on one side of the bed, ensuring
that the spring loaded knob is fully
engaged.
10. Insert the other bed rail into the
barrels on the other side of the
bed, ensuring that the spring
loaded knob is fully engaged.
3. Release the knobs and lower or
raise the rail until the spring
loaded knob "clicks" into position
(unless the rail is at the lowest
position).
4. Repeat steps 1-3 for the opposite
end of the bed rail.