Autonics ARD-DI08N-4S Руководство - Страница 7

Просмотреть онлайн или скачать pdf Руководство для Системы ввода/вывода Autonics ARD-DI08N-4S. Autonics ARD-DI08N-4S 8 страниц. Devicenet digital remote i/o
Также для Autonics ARD-DI08N-4S: Руководство (8 страниц)

Печатать страницу

ARD-D Series

Dimensions

Sensor connector type

● Mounting on DIN rail

Status LED

Item

Module status(MS)

LED

Network status(NS)

LED

Setup And Installation

Node address setup

● Two rotary switches are used for setting node address.

X10 switch represents the 10's multiplier and X10 switch represents the 1's multiplier.

Node address is settable from 0 to 63.

● Node address is changed when re-supplying the power to the unit.

After changing node address, must re-supply the power.

Mounting on panel

① Pull Rail Locks(standard terminal block type: 3EA, sensor connector type: 2EA)

on the rear part of a unit, there are fixing screw hole.

② Place the unit on a panel to be mounted.

③ Make holes on fixing screw positions.

④ Fasten the screw to fix the unit tightly.

Tightening torque should be below 0.5N·m.

C-148

● Mounting with screws

2-Ø4.5

LED status

Description

Red

Green

●

Unrecoverable error

●

Recoverable error & communication error of expansion unit

●

Normal operation

●

Power is not supplied

●

Normal standby

●

Network On-Line

●

Duplicate, MAC ID / Bus-Off

●

Time Out

●

Network Off-Line

● Connector

※ Tightening torque: 1.8 to 2.5N·m

※ Same dimensions are applied to

35.3

85.4

9.8

both basic and expansion unit.

(

: ON,

: Flash,

: OFF)

(Ex)

X10

(unit: mm)