Galaxy Print Finishing VR-930 Руководство по эксплуатации - Страница 7

Просмотреть онлайн или скачать pdf Руководство по эксплуатации для Изготовление буклетов Galaxy Print Finishing VR-930. Galaxy Print Finishing VR-930 15 страниц.

Печатать страницу

Load Staples:

1. Pull the staples magazine cap backwards until it's locked into place.

2. Open staples magazines cover.

3. Load the staples (Must use our standard 26/6 or 26/8 staples)

4. Close the magazine cover and gently unlock the staples magazine cap and

push it towards the machine's front side. Do not let the staples magazine cap

snap forward as it will smash the stick of staples.

IMPORTANT:

Use only standard staples as shown on

the right. Other staples may damage the

Staple Head or lead to bad results.

The 'No Staple' light will be turned ON

when there are only 5 staples left in the

staples magazine. Also, the machine

will stop working at this point. Remove

the remaining 5 staples and refill the

staples to the stapler magazine following

the above instructions (maximum 210

staples per load).

Tips:

Some defective staples may fall on

surface below Staple Heads.

Use the magnetic Universal Wrench

to pick them up as needed.

Caution:

Opening the machine through

any of the openings using the Universal

Wrench may cause an electric shock,

therefore beeing considered as a hazard.

Our Universal Wrench can also be used

to remove staples too.

26/6 Staples

5,000 pcs/box

26/8 Staples

5,000 pcs/box