DCA AQW5.5/10 Руководство по эксплуатации - Страница 5
Просмотреть онлайн или скачать pdf Руководство по эксплуатации для Мойка высокого давления DCA AQW5.5/10. DCA AQW5.5/10 10 страниц.
Печатать страницу
bottom. (Fig. 5)
Installation of Gun Barrel
1) Push gun barrel into pikestaff, which needs to be pressed down to the ground and
rotate 90 degrees to the left until the parts are completely geared and don't fall off. The
gun barrel of this machine can regulate the shape of water spray by rotating the
nozzle to the left and right.
2) When using the cleaning liquid, put it
into the cleaning pot and set the gun
nozzle to low pressure, and then start the
machine to press the trigger, it can spray
the cleaning liquid on the surface to be
cleaned. (Built-in cleaning pot) (Fig. 6)
Water Connection
•Connect to Pressurized Waterhead
The maximum inlet pressure is 0.7MPa/7bar and the highest temperature is 40℃,
refer to nameplate.
1) Ensure inlet strainer is put into inlet nut and not blocked.
2) Mount to inlet pipe with quick connector and the other end connects with
Waterhead.
•Note: according to the national and local regulations, for connection to drinking water
mains, water must flow through the pipe to prevent ingression of dirt and sand into
machine before connecting water pipe to the machine.
-7-
3) Turn off water supply, connect water intake to water inlet nut with quick connector
•Connect to the water supply with lower pressure
The machine can also operate in self-suction mode, which means the machine can be
connected to water containers, rivers, lakes and pools, no backflow preventer is needed
when diverse from non-portable water mains. External filter must be used when connecting
the machine from water source of lower pressure to prevent suction of impurities; water
inlet pipe should be 3m in length. We recommend using original inlet pipe kit in order to
meet these requirements, and the machine is designed to pump at the maximum distance
to water level at 50cm.
1) The machine will be placed above water
level at maximum height of 0.5 meters and
separate high-pressure pipe from water outlet.
(Fig. 7)
2）Ensure the filter is in place, connected to
water inlet pipe and ensure it is tightly
connected to water inlet.
3) Turn on the machine and press the switch to
ON position.
4) Wait until steady flow from water outlet.
5) Turn off the machine and connect high
pressure water pipe and gun assembly. (Fig. 8)
Start the Pressure Washer
Warning! Before starting the cleaning operation, check whether the machine is in upright
position and placed on flat surface, do not put it in grass. The voltage and frequency of
machine (refer to nameplate) must be consistent with that of power supply.
-8-
.