Dynaset 90 Руководство по установке - Страница 8

Просмотреть онлайн или скачать pdf Руководство по установке для Водяной насос Dynaset 90. Dynaset 90 16 страниц. Hydraulic variable displacement pump

INSTALLATION

NOTE!

• Install the suction line from oil tank to the pump shortest and straightest possible

way. Avoid tight corner so that the possible air can vaporate from the system. Air

in the oil system can cause noise and cavitation

• Installing the drain line make sure to use the drain port on the pump that is n the

highest position

• When installing the drain line into a other oil tank than DYNASET Oil tank make

sure the drain line is half way between the oil level and the bottom of the oil tank

• Do not install the clutch to the pump's shaft by hitting it

• If you are changing the pump to a existing system the system must be drained

and cleaned before installing the hydraulic pump

• After installation, if the oil flow fluctuates install the 0,8 mm jet to the LS-line

Install the pump through following steps:

1. Ensure the rotation direction. R =clockwise, L = counter-clockwise.

2. Fill the hydraulic pump's casing with filtered oil

Dynaset Oy | Menotie 3, FI-33470 Ylöjärvi, Finland | tel: +358 3 3488 200 | [email protected] | www.dynaset.com

HYDRAULIC VARIABLE DISPLACEMENT PUMP

INSTALLATION GUIDE