Autopage RS-602 Руководство по эксплуатации - Страница 3

Просмотреть онлайн или скачать pdf Руководство по эксплуатации для Дистанционное пусковое устройство Autopage RS-602. Autopage RS-602 8 страниц. Professional remote car starter
Также для Autopage RS-602: Руководство по установке (16 страниц)

Печатать страницу

CHANGING THE BATTERY IN YOUR TRANSMITTERS

XT-33: The XT-33 transmitter uses two (2) 3-volt lithium ion batteries

(#CR2016) that are sandwiched together with the (+) side facing upward.

To replace the battery, you will need to use a small flat blade screwdriver.

Locate the small notch on the lower right side of the transmitter case next

to the key ring. Using the flat blade screwdriver, carefully pry the top

case from the bottom case. It should snap apart after breaking the seal.

Before removing the batteries note the direction of the positive (+) terminal.

Place the new batteries in exactly the same manner, being careful not to

bend or damage the contact terminal. Snap the cases back together and

then test the transmitter to insure it arms and disarms the alarm.

ACTIVE

1. Press

button on the transmitter.

2. The horn, if installed will chirp once and parking lights will flash once

indicating that the system is now active. The vehicle doors will lock

upon activating when interfaced with the keyless entry system.

ACTIVE UNLOCK:

1. Press

button on the transmitter.

2. The horn will chirp twice and parking light will flash twice to indicating

that the keyless system is now unlocked. The vehicle doors will unlock

and dome lights will turn on for 30 seconds.

Optional XT-11 Operations:

To remote start the vehicle using the XT-11 press the

To unlock the vehicle on approach, Press the

If the button is pressed again within 3 seconds, the remote starter will shut down.

Note: If the vehicle can be unlocked with the factory remote, this is the preferred

method. If the factory remote will not operate when the engine is running, the

unlock wire of the RS-602 must be connected. It is recommended that the unit is

programmed to lock before and after start to insure that the vehicle is always

secure. Please see install manual page 12 feature II programming.

button once to unlock the doors.

(2) CR2016

3-Volt Batteries

LOCK:

button twice.