Autopage RF-425LCD Руководство по эксплуатации - Страница 4
Просмотреть онлайн или скачать pdf Руководство по эксплуатации для Автомобильная сигнализация Autopage RF-425LCD. Autopage RF-425LCD 14 страниц. Professional vehicle security system
Печатать страницу
PATHWAY ILLUMINATION: This feature turns the parking light "ON" for 30 seconds upon a
unlock signal and for 10 seconds upon the lock signal if programmed.
TWO STEP DOOR UNLOCK: This feature will independently unlock the driver's door only when
disarming the security system. Pushing the
seconds will unlock the entire vehicle. (Additional installation required)
AUTOMATIC RE-ARM: If this feature is selected, the security system will automatically re-arm
itself 60 seconds after disarming with remote transmitter. Automatic rearm will cancel if any door
is opened before the 60 seconds timer has elapsed.
DISARMING WITHOUT A TRANSMITTER
The Override function may be used if the remote transmitter is lost or inoperative.
1. Enter the vehicle and turn the ignition switch to 'ON' position. (Alarm will sound.)
2. Within 10 seconds push and release the valet switch
The alarm will stop sounding and enter the disarm mode. You can now start and operate the
vehicle normally.
VALET MODE:
The valet switch allows you to temporarily bypass all alarm function, eliminating the need to
hand your transmitter to parking attendants or garage mechanics. When the system is in valet
mode, all alarm functions are bypassed, however, the remote panic feature and remote door
locks will remain operational.
Enter Valet Mode:
1. From the disarmed condition, turn the
ignition to "ON" position.
2. Push and hold valet switch for 2 seconds
until the LED turns on. The LED wills
remain on as long as the system is in
'valet mode'.
Exit Valet Mode:
1. Return to normal operation, turn ignition 'ON'.
2. Push and hold valet switch for 2 seconds; the LED will turn off indicating the system is exiting
the valet mode.
POWER ON MEMORY:
This security system is equipped with circuitry that will allow the unit to remember its alarm state
if the power is lost and then reconnected.
PANIC FUNCTION:
The transmitter can be used as a remote panic switch to manually trigger the alarm in case of
emergency.
1. Press and hold the
button on the transmitter for 3 seconds. The alarm will immediately
sound.
2. During panic mode, the normal function of this transmitter button will be suspended. The
and
buttons can be used to lock and unlock the doors (if the option is installed), however
once the
button is pressed, the vehicle's starter disable device, (where installed) will be
enable allowing the vehicle to start.
3. To stop the alarm, press and hold the
Also if the
button is pressed and released, the panic mode will be turned off immediately.
4. If the button is not pressed, the alarm will automatically stop after 30 seconds.
TRIGGER THE SYSTEM
When armed, your vehicle is protected as follows:
button on the transmitter a second time within 3
Remote Door Lock Remote Door Unlock
or
or
button on the transmitter for 3 seconds.
4